Toro Screw Anchor Adaptor, Dingo Compact Utility Loader Installation guide
- Type
- Installation guide
The T
oro Company – 1998
Printed in USA
All Rights Reserved
FORM NO. 3321-509
INSTALLATION
INSTRUCTIONS
Model 22451
Screw Anchor Adaptor
for Dingo Traction Units with an Auger Drive Head
Loose
Parts
DESCRIPTION QTY. USE
Screw
anchor adaptor
1
Install on auger drive head
Hitch pin
Hairpin cotter
1
1
Attach to a screw anchor
W
arranty Registration Card
Installation Instructions
1
1
Read before use
Installing
the Screw Anchor
Adaptor
1. Attach the auger drive head to the traction unit.
2. Slide the screw anchor adaptor onto the drive
head shaft and secure it with the attachment bolt
and nut supplied with the drive head (Fig. 1).
m–3995
1
3
2
Figure 1
1. Auger
drive head
2.
Screw anchor adaptor
3.
Bolt and nut
Installation Instructions
2
Operating
the Screw Anchor
Adaptor
1. Insert the eye of the screw anchor into the screw
anchor adaptor and secure it with the supplied
hitch pin and hairpin cotter (Fig. 2).
m–3997
1
3
2
4
Figure 2
1. Screw
anchor adaptor
2.
Screw anchor
3.
Hitch pin
4.
Hairpin cotter
2. Drive to the site where the screw anchor is to be
installed and lower the point to the ground.
3. Run the engine at low speed and place the pump
starter valve in the fast (rabbit) position.
4. Pull the auxiliary hydraulics lever rearward to
begin slowly turning the screw anchor, then
lower the loader arms until the screw anchor is
in the ground.
5. Stop the auger drive head and remove the hitch
pin and hairpin cotter which secure the screw
anchor.
6. Lift the loader arms, removing the screw anchor
from the screw anchor adaptor.
-
1
-
2
Toro Screw Anchor Adaptor, Dingo Compact Utility Loader Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Toro 48" Snowthrower Adapter Kit, GMT Installation guide
-
-
-
Toro 44" Two-Stage Snowthrower, 300 Series Garden Tractors User manual
-
-
-
-
-
-
