Description
This device is an extender between USB device and host computer with embedded connector
integrated circuits on both sides of the extender.
The USB extender with the chip inside is not a passive extender. It is an active device. The USB
signals going in and out of this extender in both directions are buffered to assure signal quality.
Unlike passive USB extender the IC prevents signal degradation. The embedded “intelligent”
integrated circuit cleans, amplifies USB signal and watches USB 1.1 protocol. Its Control State
Machine enables and disables USB and Cable transmitters inside the chip depending on USB
signals.
Features
Fully compliant with USB 1.1 specification.
Provides support for any full-speed (12 Mb/s) or low-speed (1.5 Mb/s) USB devices.
Allows a USB device to have its cable length extended up to 198 ft.
Embedded USB 1.1 Transceivers prevents signal loss.
Low cost in comparison with extension of cable using Hubs or other USB extenders.
No software driver required.
Compact size
USB LED extinguished when there is no sufficient drawn current to carry signals, using
optional power adapter for external power supply.
Plug & Play