12 13
SAFETY PRECAUTIONSADVICE
• Keep this operating manual.
• Keep the coffee grinder’s casing clean.
• During cleaning observe the instructions
specified in section “Maintenance and Cleaning”.
• Place the coffee grinder only on a dry even
surface.
• Before operation make sure that the coffee
grinder is correctly assembled.
• Do not switch on the coffee grinder until the
beans container and the lid are set in the
required position in the grinding chamber.
• Adjust the coffee grind degree only when the
coffee grinder is on. Adjustment of the coffee
grind degree when the coffee grinder is off will
lead to sticking of coffee beans between the
millstones, additional operational noise and, as
a result, failure of the appliance.
• It is not recommended to operate the coffee
grinder for over 2 minutes, as it can lead to
overheating. After a long period of operation wait
until the coffee grinder cools down during 20
minutes.
• Do not place ground coffee in the container
for beans. The coffee grinder is not meant for
grinding of sticky, oily or very solid products.
• Unplug the coffee grinder after usage, as well
as before assembly, dismantling, cleaning and
storage.
• Upon detection of any damages immediately
suspend operation of the coffee grinder and bring
it to the nearest service center for testing, repair
or replacement.
• For safety reasons all operations on repair
and maintenance of the coffee grinder shall be
performed only by authorized representatives of
BORK certified service centers.
• Store coffee beans in a dark, cool and dry place.
If possible, seal the package.
• After grinding coffee quickly looses its taste
and aroma. Grind coffee beans directly before
brewing to receive the best result.
• Do not store coffee beans in the coffee grinder’s
container for a long period of time.
• Before storage switch on the empty coffee
grinder to grind beans remaining between the
millstones.
• For maximum freshness of beans switch on the
coffee grinder for 2 seconds before each use.
• Periodically clean the beans container and the
cone millstones.
• If you have difficulties with setting of the control,
switch on the empty coffee grinder for a short
period of time by pressing the START / CANCEL
button and turn the control.