When the phone completes the reboot cycle, the Sign In screen displays.
Set the Base Profile of VVX Phones to Skype Using MKC During Startup
You can set the Base Profile of a phone to Skype during the phone startup cycle in two ways: by using an
MKC method during startup or from the phone boot Setup menu.
The MKC during startup is the fastest manual provisioning method.
If your phones are not brand new and directly from the manufacturer, ensure that you reset the phones to
factory default settings before setting the Base Profile manually.
Procedure
1. Power on the phone or restart it after you have reset the phone to factory default settings.
2. A few seconds into the device's startup cycle, the phone displays the message ‘Starting
Application', press Cancel to interrupt and a Cancel soft key.
Press the Cancel soft key.
3. When the phone displays three soft keys—Start, Setup, and About—press and hold 1, 4, 9 on the
phone keypad for about 3 seconds to enter the MKC.
4. Press and hold the MKC keys to cause the Base Profile Password menu to display.
Enter the password (default 456) to change the Base Profile and press Ok.
The Base Profile menu displays.
5. Press the Edit soft key, use the keypad keys to set the Base Profile to Skype, and press Ok >
Exit.
6. Highlight Save & Reboot and press the Select soft key.
The phone reboots and displays the Sign In screen. Users can now sign in.
Set the Base Profile of VVX Phones to Skype from the Setup Menu During Startup
When you boot up the phone, you can set the Base Profile to Skype using the Setup menu available
during the phone startup process.
Procedure
1. Power on the phone or restart after you have reset the phone to factory default settings.
2. A few seconds into the device power-up cycle, the phone displays the message ‘Starting
Application, press Cancel to interrupt' and a Cancel soft key.
Press the Cancel soft key.
3. When the phone displays three soft keys—Start, Setup, and About—press the Setup soft key,
enter the password (default 456), and press Ok.
The phone displays a diagram of keypad keys you can use to navigate the Setup menu. You will
need to use these keys in the next few steps.
4. Press the Setup soft key and the Setup menu displays.
5. Using the keypad keys, scroll down, highlight Base Profile, and select the Edit soft key.
6. Using the keypad keys, set the Base Profile to Skype, and press Ok > Exit.
7. Highlight Save & Reboot and press the Select soft key.
8. The phone reboots and displays the Sign In screen.
Users can now sign in.
Deploying Poly Phones with Skype for Business
17