Rapid M2000 User Manual & Installation Manual

Brand: Rapid

Model: M2000

Type: User Manual & Installation Manual

M2000 MOBILE RAPID RADIO

Security Information:

Please read the instructions in this guide carefully to ensure proper use of the mobile radio and avoid potential hazards.

Electronic Equipment

• Do not use the radio in an area that prohibits the use of wireless devices in case of interfering with other electronic equipment.

Flammable and Explosive Areas

• Do not use the radio in areas that contain potentially ammable or explosive materials (e.g. petrol station).

Operating Environment

• Do not use the radio in dusty, humid, or heavily polluted environments, or expose the radio to magnetic elds, as it may cause

internal circuit faults.

• Do not use the equipment during a thunderstorm. This may cause equipment failure or electric shock.

• Do not expose the radio to direct sunlight for extended periods

• Do not expose the radio to water/moisture as it may lead to re or electric shock.

• Do not place the radio near ames or other heat sources such as heaters, microwaves, candles, or ovens.

Accessories Requirements

• Do not use unapproved or incompatible power sources, chargers, or batteries as this may cause re or explosions.

• Only use manufacturer approved accessories. Use of unapproved accessories may cause damage to the radio and will void the warranty.

Maintenance Service:

• Ensure the radio has been switched off and power has been disconnected before cleaning or performing maintenance of the equipment.

• When the radio is not in use, cover all sockets.

• When cleaning dust off the exterior of the equipment do not use corrosive chemicals – use neutral detergents.

• Keep the radio and accessories dry – do not attempt to dry the equipment with a hairdryer, oven, or microwave.

User Manual & Installation Guide

TS0322

Instructions before use:

• Do not use the mobile radio or charge the battery in potentially explosive environments (e.g. where gas, dust, or steam etc. is present).

• Turn off the radio when refuelling your vehicle or when parked at any refuelling station.

• Do not expose the radio to direct sunlight for extended periods. Do not place the radio near heating appliances.

• Do not expose the radio to extremely dusty conditions or water/moisture. Do not place on an uneven surface.

• Do not disassemble the radio. Maintenance should only be carried out by a qualied technician.

1300 797 897

[email protected]

www.rapidradio.com.au

Machine Chart:

Installation:

SIM Inserting Slot

1. Remove SIM card cover, insert SIM card,

place cover back on and screw to tighten.

2. Rotate xed bracket screws clockwise

until the xed bracket is tightened.

3. Connect with the power supply.

DC power input

4. Insert GPS antenna/external main antenna.

GPS antenna interface

5. Plug in the microphone.

Hand microphone interface

1 2 3 4 5

9101112

191817

Machine Chart Legend

1. Volume Knob

Turn left (-V), Turn right (+V) & Press to set

8. Return 15. Fixed Bracket Screw

2. Indicator 9. Customised Button 16. Fixed Bracket

3. LampLCD 10. Customised Button 17. GPS Antenna Interface

4. SOS 11. 2G/3G Switch Key 18. External Main Antenna Interface

5. Logo 12. SIM Switch Key 19. DC Power Interface

6. Previous Page 13. Mic Interface 20. Headset/USB Interface

Device/Installation Kit Components

1x M2000 PTToC Device 1x Fist Microphone metal bracket

1x Fist Microphone 3x Fist Microphone metal bracket mounting screws

1x Mounting Bracket - Metal 1x GPS Antenna

2x Mounting Bracket pivot screws 1x 4G LTE Patch Antenna 698-2700 MHz (Glass Mount)

2x Mounting Bracket xing screws 2x DC Power cables (1 x black 1 x red)

Rapid M2000 User Manual & Installation Manual

Rapid M2000 User Manual & Installation Manual

Rapid M2000 User Manual & Installation Manual

Other documents