Sheffield PLA1327F User manual

PLA1327 Replacement Filter

1: SOAK THE WATER FILTER

Remove the replacement filter from its packaging,

place in a bowl or sink and fully cover the filter with

water.

Soak the filter for at least 30 minutes and then rinse

off with cold clean running water.

2: CHECK THE RUBBER STOPPER

Ensure the rubber stopper as shown in Fig. A is

inserted correctly as shown in Fig. B

3: ASSEMBLE THE CHILLER UNIT

Insert filter into the upper water tank and ensure that

it is fully seated. Place the Base water tank and the

Upper water tank onto the Chiller unit.

4: FLUSH WATER

Fill the Upper water tank with cold clean water.

Operate the taps to circulate the water and to flush it

through the system to remove any black carbon dust,

repeat as many times as necessary.

NOTE: The discarded water can be used on plants

without harm.

5: OPERATE

Fill the Upper water tank with cold clean water again

and switch the Chiller “ON” at the back of the unit.

Both the “COLD” indicator (Blue) and “POWER”

indicator (Yellow) will illuminate.

Allow approximately 30-40 minutes for the water to

chill.

When the “Cold” indicator turns off the water in the

internal tank is fully chilled.

PLEASE NOTE: You may notice some fine black carbon dust coming out or the water

filter. These are actually activated carbon from the filter which are used to purify the

tap water. The black carbon dust in the water is non-toxic and will happen on all new

filters and when the water is flushed through the first couple of times.