2. Pro-Elec
  3. PELL0036

Pro-Elec PELL0036, PELL0037, PELL0038 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Pro-Elec PELL0036 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1
LED PANEL LIGHT
PELL0036, PELL0037 and PELL0038
Voltage 220-240V~50Hz
Lamp type 180 x 4014 Epiar LED (Non-replaceable)
Model Length x Width Wattage Colour Temp Lumen
PELL0036 595 x 595mm 45W 3000K 5400
PELL0037 595 x 595mm 45W 4000K 5400
PELL0038 595 x 595mm 45W 6400K 5400
6500K► Daylight
5000K► Natural White
4100K► Cool White
3500K► Warm White
2700K► Soft White
2
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical
& Electronic Equipment (WEEE). Any WEEE marked products must not be mixed with
general household waste, but kept separate for the treatment, recovery and recycling
of the materials used. Contact your local authority for details of recycling schemes in
your area. Made in China
PO Box 13362 Dublin 2
PR2 9PP
Man Rev 2.2
• Turn o or isolate the mains supply.
• Oer the unit into the suspended ceiling aperture in the location required.
• Allow the light tting to sit above adjacent tiles until the electrical connections can
be made to the in-line LED driver.
• Remove the two screws in the terminal cover on the LED driver and lift o the
cover.
• Connect the mains supply wiring as follows:
Connect the positive wire (brown or red) to the live (L) terminal.
Connect the neutral wire (blue or black) to the neutral (N) terminal.
• Replace the terminal cover and tighten the two screws.
• Ensure the LED driver is connected to the panel.
• Locate the tting into the ceiling aperture ensuring it is located correctly and
properly supported.
• Restore the mains supply.
CLEANING AND MAINTENANCE
• Clean only with a damp cloth with a little liquid detergent. Do not use any
chemicals, abrasives or solvents that may damage the product.
INSTALLATION
WHAT’s IN THE BOX
• Main light panel.
• Mains LED driver/transformer
• User’s Manual
IMPORTANT SAFETY INFORMATION
• When using electrical appliances basic safety precautions should always be
followed.
• Check that the voltage indicated on the rating plate corresponds with that of the
local network before connecting the LED driver to the mains power supply.
• Use this LED panel with supplied driver/transformer unit only. Do not connect
directly to the mains supply.
• Ensure the suspended ceiling structure can support the weight of the tting.
• For indoor use only.
/