ENG
Technical support: www.real-el.com
6
M-555
Operation Manual
* You might have to enter “0000” code to connect some models via Bluetooth.
** If an item has been already registered in the device list of sources, then the second search mode activation is
not needed. Choose only the item name and the “connect” command on the source.
Bluetooth mode
• Select the Bluetooth mode using INPUT button on the front panel of the subwoofer or INPUT
button on the remote control. After 2-3 seconds the speaker system starts the search mode.
• Activate Bluetooth search mode of your device (phone, notebook, smartphone, etc.). “M-555”
will be displayed which should be connected to*.
• Indicator light continuously when connection is successful. If there is no connection, indicator
will blink. In this case the system should be switched over to the search mode once again (turn off
and turn on Bluetooth mode)**.
FM Mode
• Use INPUT button on the front panel of the subwoofer or button INPUT on the remote control to
enter the Tuner mode.
• Press and hold AUTO on the front panel of the subwoofer or on the remote control to auto scan
the stations.
• If preset radio stations are available in the memory, you can switch from one to another by short
pressing buttons f and g on the front panel of the subwoofer or buttons f and n on the
remote control. You can also enter the frequency or the number of the preset station using
numeric pad buttons j on the remote control.
Clock Mode
• When the MSS is in the ST-BY mode, the display shows the current time. When the system is in
anotrher mode, use the CLOCK button on the remote control to see the time. The current time will
be displayed for 3-5 seconds.
• To set the current time, enter the ST-BY mode by pressing long INPUT button on the front panel
of the subwoofer or button INPUTon the remote control. To enter the time setting mode, press
SET button on the remote control (the corresponding position will start blinking on the display).
Set the required value of hours and minutes directly from the remote control numeric pad or using
buttons on the front panel of the subwoofer or on the remote control. To switch over between
setting hours/minutes and to exit the setting mode, press SET button on the remote control.
ST-BY Mode
• To enter/exit this mode, press and hold down INPUT button on the front panel of the subwoofer
or INPUT button on the remote control. The current time is shown on the display when entering
this mode.
SLEEP Mode
• The SLEEP mode enables to switch over the device in the ST-BY mode after a lapse of time
chosen by a user. Press button on the remote control to enter the SLEEP mode. To leave the
SLEEP mode, press button SLEEP on the remote control once again, while there is “0” character
on the display.
Note. Due to the constant development of the software, the actual MSS operation may differ from described in
this Manual. The most recent version of the Manual is available at www.real-el.com