Page is loading ...
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the installation instructions may cause harmful interference to radio
communications.
Canadian Compliance
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations. Cet appareil numérique de la classe A respects toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
Japanese Compliance
This is a Class A product based on the standard of the Voluntary Control Council for Interference by
Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio
disturbance may occur, in which case, the user may be required to take corrective actions.
International Declaration of Conformity
We, Turin Networks, Inc. declare under our sole responsibility that the Traverse platform (models: Traverse
2000, Traverse 1600, and Traverse 600) to which this declaration relates, is in conformity with the following
standards:
EMC Standards
EN55022 EN55024 CISPR-22
Safety Standards
EN60950 CSA 22.2 No. 60950, ASINZS 3260
IEC 60950 Third Edition. Compliant with all CB scheme member country deviations.
Following the provisions of the EMC Directive 89/336/EEC of the Council of the European Union.
Copyright © 2007 Turin Networks, Inc.
All rights reserved. This document contains proprietary and confidential information of Turin Networks, Inc.,
and may not be used, reproduced, or distributed except as authorized by Turin Networks. No part of this
publication may be reproduced in any form or by any means or used to make any derivative work (such as
translation, transformation or adaptation) without written permission from Turin Networks Inc.
Turin Networks Trademarks
Turin Networks, the Turin Networks logo, Traverse, TraverseEdge, TransAccess, TransNav, and Creating the
Broadband Edge are trademarks of Turin Networks, Inc. or its affiliates in the United States and other countries.
All other trademarks, service marks, product names, or brand names mentioned in this document are the
property of their respective owners.
Government Use
Use, duplication, or disclosure by the U.S. Government is subject to restrictions as set forth in FAR 12.212
(Commercial Computer Software-Restricted Rights) and DFAR 227.7202 (Rights in Technical Data and
Computer Software), as applicable.
Turin Networks, Inc. Preface
Page i
Preface
TABLE OF CONTENTS
1 PREFACE............................................................................................................................. 3
1.1 AUDIENCE ..................................................................................................................... 3
1.2 IF YOU NEED HELP....................................................................................................... 3
1.3 CONVENTIONS.............................................................................................................. 3
Turin Networks, Inc. Preface
Page 3
1 PREFACE
This document is a field guide for the hardware installation and initial configuration of the Turin
TraverseEdge 50 (TE-50) Product.
The manual is divided into chapters for easy reference. The index outlining the chapters is located in
the document titled “Index”. Each chapter also contains a table of contents for that particular chapter.
This guide describes how to unpack and install the main hardware chassis and the installation and
removal of IMs. The installer is introduced to the operation of the front panel and diagnostic features
of the TE-50 products and the interpretation of the front panel displays. TransNav EdgeView is
introduced for basic port configuration and connection.
1.1 AUDIENCE
This document is intended for use by Communications Technical staff that will physically install and
maintain the TE-50 in a private or public voice and/or data service network.
Installing technicians should be familiar with the communications network protocols, nature and
requirements of services and systems connected to the TE-50.
1.2 IF YOU NEED HELP
If you need assistance while working with TE-50 products, contact the Turin Networks Technical
Assistance Center (TAC):
• Inside the U.S.: 1-866-TURINET (866-887-4638).
• Outside the U.S.: 707-665-4400.
• Online: www.turinnetworks.com/technical.htm.
TAC is available 6:00AM to 6:00PM Pacific Time, Monday through Friday (business hours). When the
TAC is closed, emergency service only is available on a callback basis. E-mail support (24-hour
response) is also available through at: [email protected].
1.3 CONVENTIONS
This publication uses the following conventions:
Note: contains information that may be useful to the reader.
Caution: specifies important information that will assist with a successful implementation of
the product described.
Warning: contains information that may impact on issues of personal safety.
Turin Networks, Inc. TE-50 User Guide Table of Contents
Page i
TABLE OF CONTENTS
SECTION 1: TE-50 PRODUCT OVERVIEW
Chapter 1-1: Introduction to Turin TraverseEdge 50 Products
Chapter 1-2: TE-50 Chassis and Operating Environment
Chapter 1-3: TE-50 Integrated Access (IA) Product Specifics
Chapter 1-4: SDH/SONET (SS) Product Specifics
Chapter 1-5: SDH-AU4 Terminal Mode Point-to-Point Configuration Example
Chapter 1-6: SONET OC-3 Ring UPSR Configuration Example
Chapter 1-7: SDH-AU3 Linear 1+1 Configuration Example
Chapter 1-8: SONET OC-12 Ring UPSR Configuration Example
SECTION 2: TE-50 INTERFACE MODULES
Chapter 2-1: Interface Module Overview
Chapter 2-2: Dual E1 IM
Chapter 2-3: MPS IM
Chapter 2-4: FXS IM
Chapter 2-5: E&M IM
Chapter 2-6: STM-1 (OC-3) IM
Chapter 2-7: E3 /DS-3 IM
Chapter 2-8: Dual T1 IM
Chapter 2-9: Dual Ethernet IM
Chapter 2-10: Octal E1 IM
Chapter 2-11: Octal T1 IM
Chapter 2-12: Dual CoDirectional IM
Chapter 2-13: E3 – DS3 (M13) Multiplexer IM
Chapter 2-14: STM-1 & OC-3 Linear (1+1) IM
Chapter 2-15: Dual FXO IM
Chapter 2-16: STM-1 Electrical (STS-3) IM.doc
Chapter 2-17: TeleProtection Fiber IM
SECTION 3: TRANSNAV EDGEVIEW
Chapter 3-1: TransNav EdgeView Setup and Configuration
Chapter 3-2: Node and Network Clocks
Chapter 3-3: Digital Access Cross Connect Switch (DACS)
Chapter 3-4: SDH/SONET – Tributary Connections
Chapter 3-5: Remote Management of TE-50 Products
Chapter 3-6: Ethernet – Tributary Connections
Chapter 3-7: E3-DS3 Mux – Tributary Connections
Turin Networks, Inc. TE-50 User Guide Table of Contents
Page ii
SECTION 4: APPLICATION NOTES
Chapter 4-1: Voice Networking Applications
Chapter 4-2: MPS DCE/DTE Clocking
SECTION 5: APPENDICES
Appendix A: Turin Cables
Appendix B: Software Updates with TE-50Upgrade
Appendix C: Types of Signaling for Voice Networks
Turin Networks, Inc. Ch1-1 Introduction to Turin TraverseEdge 50 Products.doc
Page i
CHAPTER 1-1: TABLE OF CONTENTS
1 INTRODUCTION .................................................................................................................. 1
2 TURIN TE-50 PRODUCTS ................................................................................................... 2
2.1 TE-50-IA.......................................................................................................................... 2
2.2 TE-50-SS ........................................................................................................................ 2
2.3 TE-50-EV ........................................................................................................................ 3
2.4 INTERFACE MODULES ................................................................................................. 3
2.5 TRANSNAV EDGEVIEW ................................................................................................ 3
TABLE OF FIGURES
FIGURE 1 - TE-50-IA ........................................................................................................................................ 2
FIGURE 2 - TE-50-SS....................................................................................................................................... 3
Turin Networks, Inc. Ch 1-1 Introduction to Turin Products
Page 1
1 INTRODUCTION
All Turin products are designed to assist telecommunications network operators to provide a large
number of voice and data services from a confined space and in a highly efficient manner.
There are three product ranges of Turin TE-50 family nodes available. The TE-50-SS, TE-50-IA, and
TE-50-EV, which are housed in a single Rack Unit (1RU = 1.75 inches high) rack mount device with
16 available slots for Interface Modules (IMs). (Refer to Figure 1) These slots are numbered 01-16.
All TE-50 nodes allow for a variety of voice and data services using insertable IMs that can be added
and removed as required. This allows service providers to optimize their networks by installing only
the actual services required when they are required.
The configuration and management of all nodes and IMs is performed in TransNav EdgeView, a
Windows® based Element Management System GUI application.
An introduction to each product follows. For more details, example applications and operating
instructions refer to the specific online help and/or chapters of the Turin Installation and Configuration
Manual.
Turin Networks, Inc. Ch 1-1 Introduction to Turin Products
Page 2
2 TURIN TE-50 PRODUCTS
2.1 TE-50-IA
The TE-50-IA is a modern channel bank multiplexer solution, provided in a small single Rack Unit
device that provides up to 30 or 24 channels of data or voice connectivity for an E1 or T1 trunk circuit
connection respectively. Just as easily the TE-50-IA can be used to groom up to 32 x fractional E1
and T1 interfaces in the internal 1024 x 1024 x DS0 Digital Access Cross Connect Switch.
Figure 1 - TE-50-IA
The use of Interface Modules minimizes capital expenditure and simplifies service connectivity.
2.2 TE-50-SS
The TE-50-SS supports both Path based protection methodologies (SNCP or UPSR) and circuit
switched protection methodologies (MSP or Line 1+1).
The TE-50-SS integrates SDH/SONET transmission and multiplexing with Optical Multiplexing, Cross-
connect, and Integrated Access functionality. This saves the user investing in separate traditional
access and switching equipment.
The system is standards based and interworks with traditional PDH and SDH/SONET networks
allowing customers to evolve their networks with operational simplicity.
Turin Networks, Inc. Ch 1-1 Introduction to Turin Products
Page 3
Figure 2 - TE-50-SS
2.3 TE-50-EV
The TE-50-EV is a data multiplexer that combines T1 and 10/100 Base T Ethernet transmission
across DS-3 trunks, supporting up to 8 10/100 Base T Ethernet IMs and 28 Dual T1 IMs. The
TE-50-EV can only be connected with another TE-50-EV.
2.4 INTERFACE MODULES
The Interface Modules (IMs) come in a number of variants, allowing connection to a variety of voice
and data services. Each IM’s I/O is presented on its front panel.
Figure 3 – Interface Module
More information on the IMs is available with their individual configuration and operation in Chapter 4
of this section.
2.5 TRANSNAV EDGEVIEW
TransNav EdgeView is a Windows® based Graphical User's Interface EMS application that allows a
user to manage and configure TE-50 nodes and Interface Modules via software.
For more information on TransNav EdgeView, refer to Section 3 of this TE-50 manual.
/
