V-ZUG 5105800005 User guide

Page is loading ...

8

Connect the appliance to a mains power source.

On electronic models, this may cause a signal tone to sound, indicating that the temperature alarm has

been triggered. Press the warning tone shutoff switch. If present, place the antibacterial odor filter in the

fan as illustrated on the filter packaging.

Note: After switching on the appliance, you must wait for 4-5 hours until the correct storage temperature

has been reached for an appliance filled normally.

FIRST-TIME USE

Clean the appliance occasionally with a cloth and a solution of hot

water and a neutral cleaning agent specifically intended for the cleaning

of refrigerator interiors. Do not use any abrasive items or substances.

Using the tool provided (see Fig.), clean drain aperture in back panel

of refrigerator near the fruit and vegetable tray on a regular basis to

assure continuous and correct condensate draining.

Before maintenance and repair work, always disconnect the mains plug

on the appliance or isolate the mains power supply.

Caution: Refrigerator accessories must not be rinsed in the dishwasher.

MAINTENANCE AND CLEANING OF THE

APPLIANCE

If the product is equipped with LED lamps as shown,

contact the Technical Customer Service whenever these

need to be replaced.

LEDs last longer than conventional bulbs, improve

visibility inside the appliance and are environment-

friendly.

REPLACING LEDS

9

Disconnect the power supply from the appliance, empty it, if necessary defrost it, then clean it. Keep the

doors open slightly to enable air to flow in. This prevents the formation of mold and noxious odors.

WHENEVER THE APPLIANCE

IS NOT IN USE

Keep the doors closed to enable the food in the fridge to stay cold for as long as possible.

Never refreeze foodstuffs, even if only partially defrosted. In the event of an extended power cut, the

power failure alarm may also be triggered (on electronic models).

IN THE EVENT OF A POWER CUT

Fresh food and drink can be stored in the chiller compartment.

The chiller compartment defrosts automatically.

The occasional appearance on the internal back panel of the chiller compartment indicates that the

automatic defrost function is operating. The condensate (thaw water) automatically flows through a drain

aperture and into a receptacle in which it evaporates.

On certain models, the product can be equipped with a special ‘Zero Degree’ compartment suitable for

the storage of fresh meat and fish.

Note: Ambient temperature, frequency of door opening and installation location of the appliance are all

factors that can affect the interior temperature in both areas. Note these factors when setting the

temperature.

Note: Under very humid ambient conditions, condensate can form inside the chiller compartment,

especially on glass trays. In this case, it is advisable to cover receptacles containing fluids

(e.g. a pot containing consommé), and to wrap foods containing a high proportion of fluid (e.g.

vegetables).

Removal of the vegetable drawer

Pull the drawer out as far as possible, grip it and lift it out.

To simplify the task of filling the vegetable drawer, it may be easier to empty the two lower trays in the

(and to remove them), then to lift out the drawer.

CHILLER COMPARTMENT

10

Model with separate freezer compartment

Frozen food can be stored in the freezer compartment (for the length of time specified on the

packaging) and fresh food can be frozen. The quantity of foodstuffs that can be frozen within a 24 hour

period is indicated on the type plate. Place fresh food in the fast-freeze area of the freezer compartment

(see abridged instructions) and leave sufficient room around the packaging for air to circulate. Never

refreeze foodstuffs, even if only partially defrosted. The food must always be packaged in a way that pre-

vents the ingress of water, fluid or condensation.

Production of ice cubes

Fill the ice cube trays (if provided) to the 2/3rds point with water and place them in the freezer compar-

tment. Never use sharp or pointed tools to break off the ice.

Drawer removal (dependent on model)

Pull the drawer out as far as possible, lift it and remove it. To increase the storage capacity, you can also

use the freezer compartment without drawers.

Ensure that the door closes correctly after placing foodstuffs on the wire trays ./ shelves.

Models with an internal freezer compartment

Fresh food can also be frozen in the freezer compartment .

The quantity of foodstuffs that can be frozen within a 24 hour period

is indicated on the type plate.

Freezing fresh food:

• Place the food directly on the base of the freezer compartment

• Place the food in the center of the compartment, avoiding con-

tact with food that is already frozen, maintaining a distance of about 20

mm on all sides.

FREEZER COMPARTMENT

On models with the No Frost feature, no further defrosting operations are required.

On other models, the formation of ice is a normal occurrence.

The quantity and speed of ice formation depends on ambient conditions, and on how frequently the door

is opened. It is advisable to reduce the temperature setting or, if present, to activate the fast-freeze

function (see abridged instructions) four hours prior to removal of the food from the freezer

compartment to extend the life of the food preserving agents during the defrosting process. Shut down

the appliance to defrost it, and remove the drawers. Place the frozen food items in a cool place. Leave the

door open to enable the unit to defrost, i.e. the ice to thaw. It is advisable to put absorbent cloths on the

floor of the freezer compartment and to wring them out at regular intervals to limit the spread of thaw

water.

Clean the interior of the freezer compartment and dry it carefully.

Switch the appliance back on and place the food items back in the appliance.

DEFROSTING THE FREEZER

COMPARTMENT

(MODEL-DEPENDENT)

11

If you get in touch with us because of an

operational fault or a new order, please always

quote the Fabrication Number (FN) and the

designation of your appliance. Enter these details

here, and also on the adhesive Service label

supplied with the appliance (attach this label to a

clearly visible place, or in your telephone

directory).

FN Appliance

- You will find these details on the warranty

certificate or on the original invoice, and/or on the

type plate of the appliance. The type plate is

located on the left, near the left-hand vegetable

tray.

In the event of malfunctions, use our Freefone

number 0800 850 850 to contact your nearest

V-ZUG AG Service-Center.

To prevent unnecessary error messages, please

check that the power supply is functioning

correctly (i.e. is the connector plugged in) before

calling out a service engineer? Is the fuse intact?).

Inquiries, orders, Service agreement

Should you have any inquiries or problems of an

administrative or technical nature, or should you

wish to order spare parts and accessories, please

contact our head office in Zug directly,

Tel. +41 58 767 67 67.

To maintain all of our products, you have the

option of signing up to a Service agreement from

the end of your one-year warranty cover. We

would be delighted to send you the relevant

documents.

REPAIR SERVICE

• Do not set up the appliance near a heat source.

Setting up the appliance in warm rooms, close

to heat sources (heating systems, ovens) or with

exposure to direct sunlight will cause them to

use more power, i.e. to be less economical, so

locations of this nature should be avoided.

• If this is not possible, always maintain the

following minimum distances:

- 30 cm from coal-burning or oil-fired ovens;

- 3 cm from electric and/or gas ovens.

• The spacers (if provided) should be fitted to the

back panel of the condenser on the back of the

appliance.

• Set up the appliance in a dry and well-ventilated

place, and if necessary, adjust the front feet to

get it into a level position.

• Clean the interior.

• Install the accessories.

Electrical connection

• The electrical connections must comply

with local specifications.

• The type plate inside the appliance provides

details of rated voltage and power levels.

• Legislation requires the appliance to be

electrically grounded. The manufacturer is

not liable for any damage or injury to

items, people or domestic pets resulting

from any failure to follow these stipulations.

• If the connector and receptacle are not of the

same type, have the receptacle replaced by a

qualified electrician.

• Never use extension cables or multi-gang

adapters.

Electrical isolation (shut-down)

It must be possible to isolate the appliance

electrically by unplugging its mains power

connector, or by using a front-mounted

(‘upstream’) two-terminal switch.

INSTALLATION

Page is loading ...

GBD F I

Printed in Italy 10/14

V-ZUG AG

Industriestrasse 66, 6301 Zug

Tel. +41 58 767 67 67, Fax +41 58 767 61 61

[email protected], www.vzug.com

Service-Center: Tel. 0800 850 850

J51057.010-0

5019 600 01106

V-ZUG 5105800005 User guide

V-ZUG 5105800005 User guide

in other languages

Related papers

Other documents