MODEL: SOC042_028M
Menards
ASSEMBLY INSTRUCTIONS
ATTENTION
Contact
MD Sports
Customer Service
DO NOT RETURN
TO THE STORE
Toll Free: 877-885-1635
* For additional resources and Frequently
Asked Questions, please visit us at
themdsports.com
www.themdsports.com
SOC042_028M
1
(Continued on the next page.)
NOTICE!
This product is covered by a limited warranty that is effective for 90 days from the date of purchase. If, during the limited
warranty period, a part is found to be defective or breaks, we will offer replacement parts at no cost to you, the customer. The
only exceptions to the warranty include mainframes, table tops, playing surfaces, batteries or tools.
The above warranty will not apply in cases of damages due to improper usage, alteration, misuse, abuse, accidental damage
or neglect.
This Limited Warranty gives you specific legal rights and you may also have other rights which vary from one State (province)
to another.
A PURCHASE RECEIPT (or other proof of purchase) will be required before any warranty service is initiated. For all requests
for warranty service, please feel free to contact our Consumer Service Department at:
TOLL FREE: 877-885-1635
WEBSITE: www.themdsports.com
Please be aware of your product’s Limited Warranty for the return/refund policy from the store. We, at Medal Sports, cannot
handle the product which is out of product’s limited warranty since we only provide available parts. Thank you!
PLEASE CONTACT US BEFORE RETURNING
THE PRODUCT TO THE STORE.
LIMITED 90 DAYS WARRANTY
STAPLE YOUR RECEIPT HERE
1 - Please leave your name, address, phone number, model number, parts needed on the answering machine if there is no
attendant. Failure to do so will result in a delay in shipping parts to you.
2 - Please review the replacement parts list and make sure that you have all of your parts before beginning assembly.
For questions that may arise or for missing/damaged parts, please contact us.
3 - Since you build all tables upside down, please inspect tabletops or playing surfaces right away before putting together, all
damaged table tops/playing surfaces need to be returned to the store. Please contact the retailer for their return policy.
www.themdsports.com
SOC042_028M
2
(Continued on the next page.)
Phillips Screwdriver - Not Included
Standard (Flat Head Screwdriver) - Not Included
Wrench - Included
Allen Key - Included
CAUTION!
Electric screwdrivers may be helpful during assembly; however, please set a low torque and use extreme
caution.
1 - This product is intended for INDOOR use only.
2 - Please do not sit, climb, or lean on the product.
3 - Please do not drag the product when moving it in order to avoid damaging the legs.
4 - Please only use spray furniture polish to clean the exterior surfaces of the product.
5 - This is not a child's toy, adult supervision is required for children playing this game.
Power Tools
- Set Low Torque
High Torque
over tightened
WARNING:
Adult assembly required.
WARNING:
CHOKING HAZARD
TOOLS REQUIRED
ASSEMBLY TIPS
IMPORTANT NOTICE!
Strong Adults Needed
No Children in
Assembly Area
Keep away from pets
Do not use or keep product
outdoors. For indoor use only.
No wet/humid conditions.
X 2
1 - Please read the instructions carefully, and follow all assembly, operation, and safety instructions properly in order to avoid
damage or injury. For the assembly, at least two adults are required.
2 - Some figures or drawings may not look exactly like your product. Please read and understand the text before beginning each
assembly step.
SOC042_028M PARTS LIST
www.themdsports.com
SOC042_028M
3
(Continued on the next page.)
x2
FOR FIG. 2
1
Side Apron
x2
FOR FIG. 1, 4
2
End Apron
x1
FOR FIG. 7
3
Leg - A
x1
FOR FIG. 7
4
Leg - B
x1
FOR FIG. 3
5
Playfield
x2
FOR FIG. 6
6
Support Brace
x2
FOR FIG. 12
7
End Leg Panel
x2
FOR FIG. 16
8
Goal Box - Top
x2
FOR FIG. 16
9
Goal Box - Bottom
x6
FOR FIG. 14
10
3-Hole Rod
x6
FOR FIG. 15
11
Handle
x6
FOR FIG. 15
12
Rod End Cap
x2
FOR FIG. 15
13
Slide Scorer
x4
FOR FIG. 13
14
Leg Leveler
x2
FOR FIG. 8
15
Buckle
x4
FOR FIG. 8, 10
16
Plastic Screw
x12
FOR FIG. 14
17
Rod Washer
x12
FOR FIG. 14
18
Foam Bumper
x9
FOR FIG. 14
19
Player - Black
x9
FOR FIG. 14
20
Player - Red
x4
FOR FIG. 8, 10
21
Safety Support
x2
22
Soccer Ball
x1
FOR FIG. 7
23
Leg - C
x1
FOR FIG. 7
24
Leg - D
x1
A1
4mm Allen Key
x4
FOR FIG. 9, 11
A2
3/16"×7/8" Bolt
x4
FOR FIG. 8, 10
A3
6x22mm Screw
x4
FOR FIG. 7
A4
1/4"X2-1/2" Bolt
x8
FOR FIG. 13
A5
1/4"X2-1/4" Flat Head Bolt
x28
FOR FIG. 2, 5, 7, 8, 9, 10, 11
A6
1/4" Washer
x16
FOR FIG. 1, 4, 12
A7
1/4" Barrel Nut
x4
FOR FIG. 7
A8
1/4" Nut
SOC042_028M PARTS LIST
www.themdsports.com
SOC042_028M
4
(Continued on the next page.)
SOC042_028M PRE-INSTALLED PARTS
ASSEMBLY INSTRUCTIONS:
1. Find a clean, level place to begin the assembly of your product.
2. Remove all the parts from the box and verify that you have all of the listed parts as shown on the parts list pages.
Carefully cut or tear the four corners of the box so that the bottom of the box can be used as your work surface.
x4
FOR FIG. 6
A9
4x35mm Screw
x4
FOR FIG. 15
A10
P3x18mm Screw
x8
FOR FIG. 2, 5
A11
1/4"x1-1/4" Bolt
x8
FOR FIG. 16
A12
4x12mm Screw
x12
FOR FIG. 2
P1
Plastic Rod Bushing
x2
FOR FIG. 2
P2
Plastic Ball Entry Rim
x4
FOR FIG. 13
P3
Leg Cap
FIG. 1
X 1
2
X 4
A7
x18
FOR FIG. 14
A13
3x18mm Hardened Screws
x4
FOR FIG. 9, 11
A14
3/16" Nut
Note: Please note the hole
and the hole alignment.
2
2
A7
The Hole
x1
A15
Wrench
X 2
1
X 4
A6
X 12
P1
X 2
P2
X 4
A11
www.themdsports.com
SOC042_028M
5
(Continued on the next page.)
FIG. 3
FIG. 2
X 1
5
1
1
Groove
Note: The playing surface should
face down when assembling.
5
P1
P2
1
2
A6
A11
1
2
1
www.themdsports.com
SOC042_028M
6
(Continued on the next page.)
FIG. 5
FIG. 6
X 2
6
X 4
A6
X 4
A9
X 4
A11
FIG. 4
X 1
2
X 4
A7
Note: Please note the hole
and the hole alignment.
2
A7
2
A7
The Hole
A6
A11
1
1
2
6
A9
6
www.themdsports.com
SOC042_028M
7
(Continued on the next page.)
FIG. 7
X 1
3
X 1
4
X 1
23
X 1
24
X 4
A4
X 4
A8
X 8
A6
3
4
23
24
Narrow
Wide
Note: Legs should angle out.
SIDE VIEW
3
4
23
24
A6
A4
A6
A8
www.themdsports.com
SOC042_028M
8
(Continued on the next page.)
FIG. 8
FIG. 9
X 2
A6
X 2
21
X 2
16
X 2
15
X 2
A3
3
4
23
24
21
A14
A6
A2
X 4
A6
X 2
A14
X 2
A2
16
15
21
A3
A6
3 4&
Note: Only Leg - A and Leg - B
(#3 and #4) will be installed
with Buckle (#15).
3
4
23
24
www.themdsports.com
SOC042_028M
9
(Continued on the next page.)
FIG. 10
FIG. 11
X 4
A6
X 2
A14
X 2
A2
X 2
A6
X 2
21
X 2
16
X 2
A3
3
4
23
24
3
4
23
24
A6
A2
A14
21
21
16
A6
A3
24 23&
21
X 4
P3
www.themdsports.com
SOC042_028M
10
(Continued on the next page.)
FIG. 12
FIG. 13
X 4
14
X 8
A5
X 2
7
X 8
A7
A7
Note: Please note the hole
and the hole alignment.
7
A7
The Hole
7
7
14
7
P3
A5
Note: Go back and make sure that all connections are tightened.
DO NOT LEAN THE
TABLE ON ITS LEGS
HOLD BY THE
TABLETOP
CABINET
DO NOT HOLD THE
TABLE BY THE LEGS
CAUTION: Two strong adults are recommended
to turn over the table as shown.
1. Lift the table off the ground.
2. Turn the table over.
3. Place all four feet on the ground at the same
time.
www.themdsports.com
SOC042_028M
11
(Continued on the next page.)
FIG. 14
X 6
10
X 12
17
X 12
18
X 9
19
X 9
20
X 18
A13
= Black
= Red
Order of players
(Overhead View)
10
10
10
10
10
10
Note: The Rods have a hole at the
end where their Handles will go.
17
17
20
19
&
18
P1
18
The Hole
10
Note: Players of the same team color should have
Handles (#11) on the same side, and each team’s
players should be facing their opponent.
20
19
&
A13
FIG. 15
FIG. 16
X 2
8
X 2
9
X 6
11
X 6
12
X 2
13
X 4
A10
X 8
A12
www.themdsports.com
SOC042_028M
12
(Continued on the next page.)
11
12
Note: The goalie should be at
the left side of each player.
13
A10
11
11
A12
A12
8
9
www.themdsports.com
SOC042_028M
13
(Continued on the next page.)
THE LEGS CAN BE FOLDED TO PLAY ON DESK OR FLOOR:
Step 1
Note: Two adults are required to
turn this table over.
Note: Fold the Leg - A (#3) and Leg - B (#4)
- Make sure that the Safety Support are
unlocked in the correct position.
Step 2
3
4
www.themdsports.com
SOC042_028M
14
(The last page)
para voltear la mesa.
YOU ARE NOW READY TO PLAY!
Step 4
Note: Two adults are required to
turn this table over.
Step 3
Note: Fold the Leg - C (#23) and
Leg - D (#24) - Make sure that the
Safety Support are unlocked in
the correct position.
23
24
/
