2. Acclaim Lighting
  3. AL DOT AC

Acclaim Lighting AL DOT AC User guide

  • Hello! I am an AI chatbot trained to assist you with the Acclaim Lighting AL DOT AC User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
ELECTRICAL & WIRING
Guide subject to change without notice
acclaimlighting.com
1
AL DOT AC
TM
INSTALLATION GUIDE
Before installing, please verify the electrical plan. Each xture consumes a maximum of 18W, and must be
directly connected to AC power and DMX individually.
Ensure that the mains power is supplied from a suitably protected source and initial connections are made
within sutiable, wet location enclosures (if applicable).
AC input 100-277VAC
Junction Box* (by others)
See diagram above for linkable DMX wiring
*some municipalities require the separation of low voltage and high voltage conductors with a barrier within the electrical box
5’ hybrid feed cable
DMX Controller
ADDRESSING FIXTURES
Guide subject to change without notice
acclaimlighting.com
1
AL DOT AC
TM
INSTALLATION GUIDE
MOUNTING
Guide subject to change without notice
acclaimlighting.com
1
AL DOT AC
TM
INSTALLATION GUIDE
Intalling on a 4” round electrical box:
1. Remove side mounted hex screws to release the mounting ring.
2. Attach mounting ring to the 4” round electrical box.
3. Align AL Dot AC to mounting ring and re-attach hex screws
Make sure electrical box is properly sealed to ensure wet location rating
When installing directly to a surface instead of an electrical box, use screws through the mounting ring that
are appropriate for the mounting surface. You may need to drill a hole that is a minimum of 1.5” in diameter
to accomodate the cable and wire gland.
/