2. Sapling
  3. 50 Watt Power Supply

Sapling 50 Watt Power Supply Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Sapling 50 Watt Power Supply Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Page 1
Sapling, Inc. 1633 Republic Road Huntingdon Valley, PA 19006 Phone: (215) 322-6063 Fax: (215) 322-8498 www.Sapling-Inc.com
50 Watt Power Supply Installation Manual (V 3.0)
RED
WIRE
(+)
BLACK
WIRE
(-)
RED 2 PIN FEMALE CONECTOR (24V DC)
ORANGE 3 PIN FEMALE CONECTOR (110V)
1. IMPORTANT! Disconnect the power.
2. IMPORTANT! We have included two sets of cables. One set is for Surface-Mount master
clocks and one is for Rack-Mount master clocks. You only need to use the set of cables that
applies to your model master clock.
3. Connect the red female connector to the male 2-pin connector as indicated in the drawing
below. Also, be sure the polarity is correct as shown in the drawing.
4. There are two orange connectors on the master clock relay board in the upper right corner.
One of these connectors does not have any wires attached. Remove that connector and
attach the orange 3-pin female connector from the additional power supply.
/