Mammoth Hail Guards, 547846, 547847, 558857, 559411 Installation guide

Brand: Mammoth

Model: Hail Guards, 547846, 547847, 558857, 559411

Type: Installation guide

INSTALLATION

INSTRUCTIONS

NEIHG06

Fig ure 4

Fig ure 6

Fig ure 5

Step 1:

Check for correct number of parts. See

list below.

1 - Rear Hail Guard (A)

2 - Side Hail Guard (B & C)

1 - Rear Top Panel (D)

2 - Side Top Panel (E & F)

6 - Vertical Side Panel (G)

1 - Hardware Package

44 - #10- 16 x ½ Screw

1 - Installation Instruction

Step 2:

Take (G) vertical side panels and

assembly to their respective top panel

(D), (E) and (F)

Step 3:

Secure (A), (B) and (C) hail guards in

between clips on the vertical side panels

and close clips to hold guard in position.

Step 4:

Slip top flange of the assembled kit under

the top pan of the unit and fasten to unit.

Use the existing screws on the unit and

self-drilling screws to attach to the corner

posts.

FLANGE

CORNER POST

REAR HAIL GUARD

SIDE HAIL GUARD

The Hail Guard is designed to prevent damage to the condensor coil of the unit. The following list of parts are required:

FORM# 601A-0808 (601A-0298)

INSTALLATION INSTRUCTIONS FOR

547846 / 547847

HAIL GUARD USED WITH R4GM 072

P6SD, Q6SD, R6GD 024-060 UNITS

SUPERSEDES 10-26-04

SEPTEMBER 2, 2008

Mammoth Hail Guards, 547846, 547847, 558857, 559411 Installation guide

Mammoth Hail Guards, 547846, 547847, 558857, 559411 Installation guide

Mammoth Hail Guards, 547846, 547847, 558857, 559411 Installation guide

Related papers

Other documents