(2) 1/4-20 x 15mm JC bolts
with
(2) 1/4-20 locknuts
0190792 Page 1 of 1
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
© 2018 Spectrum Industries Inc., All rights reserved.
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
Tools
Required
Installation
Pull-out keyboard tray
for Pivot Workstation™
37329
(1) Pull-out keyboard
tray assembly
1. Carefully ip the workstation upside-down onto a non-abrasive
surface. This may require 2-3 people.
2. Relocate the (2) existing worksurface cord wraps to the bottom of
the assembly as shown with 1/4-20 x 15mm JC bolts and locknuts.
Figure 1.
3. Attach the keyboard tray assembly to the worksurface with (10) #14 x
7/8” PHSM screws.
4. Route the power cord through the side grommet.
Figure 1
(10) #14 x 7/8” PHSM
Keyboard tray assembly
Cord wraps
or
Worksurface
(10) 0101382
#14 x 7/8” PHSM
(4) 052605
1/4-20 x 15mm
JC bolt
(4) 041943
1/4-20 locknut
Relocate existing
worksurface cord
wraps
with (2) 059984 2”
Grommets installed
-
1
Spectrum Industries Pull-out Keyboard Tray Owner's manual
- Type
- Owner's manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Spectrum Industries Locking Pull-out Drawer Owner's manual
-
Spectrum Industries 55379 Owner's manual
-
-
-
-
-
-
-
-