Lenoxx 8821 Instructions Manual

Lenoxx
Brand
Lenoxx
Model
8821
Type
Instructions Manual

Lenoxx 8821

The Lenoxx 8821 is a ride-on swing car designed for children aged 3-6 years. It is suitable for both indoor and outdoor use and provides a fun and active way for kids to play. The car is made from durable materials and features a low center of gravity for stability. It does not require any batteries, gears, or pedals to operate, making it easy for kids to use.

To propel the car forward, children simply turn the steering wheel back and forth continuously. To go in reverse, they rotate the steering wheel 180 degrees. The car can be brought to a stop by simply stopping turning the wheel. It is important to note that adult supervision is required at all times when children are using the car. Children should wear protective equipment such as a helmet when riding the car.

Lenoxx 8821

The Lenoxx 8821 is a ride-on swing car designed for children aged 3-6 years. It is suitable for both indoor and outdoor use and provides a fun and active way for kids to play. The car is made from durable materials and features a low center of gravity for stability. It does not require any batteries, gears, or pedals to operate, making it easy for kids to use.

To propel the car forward, children simply turn the steering wheel back and forth continuously. To go in reverse, they rotate the steering wheel 180 degrees. The car can be brought to a stop by simply stopping turning the wheel. It is important to note that adult supervision is required at all times when children are using the car. Children should wear protective equipment such as a helmet when riding the car.

RIDE-ON SWING CAR
Model no: 8821 | Batch no: PR3767
Please read and retain these instructions for future reference.
The illustrations used in this manual are to illustrate the operation method and structure of the
product. Where there is a small difference between the physical item and the illustrations, please
take the physical as the standard.
FEATURES:
Safe & stable
Low centre of gravity
Durable material
Indoor or outdoor play
No batteries, gears or pedals
HOW IT WORKS:
1. Place the ride on swing car onto a smooth, flat surface.
2. Sit with the feet on the footrests. Lean slightly forward and grip the steering wheel.
3. To propel the car forward, turn the steering wheel back and forth continuously. To go in reverse,
rotate the steering wheel 180 degrees.
4. To bring the ride on swing car to a stop, stop turning the wheel, wait for the car to slow, and
come to a stop.
SAFETY INFO:
1. When unpacking the ride on swing car, properly dispose of all plastic wrappings.
2. Adult supervision is required at all times.
3. Failure to follow the instructions may affect the safety of children.
4. This product is designed for use by children from 3 years to 6 years of age.
5. Protective equipment such as a helmet is recommended (protective equipment is not included).
6. Assembly must be completed by an adult.
7. Each time before use, ensure that all removeable parts and fasteners are firmly in place.
8. Only one child can use this at a time.
9. A child who is riding is not to be pushed.
10. Do not allow a child to stand on the ride-on.
11. Do not let children ride in the street, anywhere dangerous including stairs, doorsteps, steep
slopes, streets/roads, vehicle traffic, next to bodies of water and away from other obstacles. Use
during day light hours or in an illuminated area is advised to avoid accidents in the dark.
12. Do not drive on long or wet grass, mud, soft ground, gravel or sand.
13. It is not recommended for use on wooden floors. The wheels may damage some floors.
14. The maximum carrying capacity is 30kg.
ASSEMBLY:
Included parts:
1. Body
2. Steering wheel assembly
3. Front wheel assembly with foam sheath
4. Rear right wheel (A), Rear left wheel (B)
5. Steering wheel cap
Tools required (not included): rubber mallet, 20mm socket wrench.
Steps:
Fit the notch on each wheel housing into the body. Push the wheels in at a 45 degree angle. When
installed correctly, the rear wheel flare out from the body.
Warning: The rear wheel housing can not be removed once locked into place.
Strike the rear wheels with a rubber mallet (not included) to secure them in place.
Remove the foam sheath from the front wheel assembly.
Guide the front wheel shaft through the body, into the foam sheath, and through the hole at the top
of the body.
Ensure it is inserted as far as it will go; it must be flush with the body. Wiggle into place if necessary.
Strike the base of the front wheel assembly with a rubber mallet.
The metal bearing should be seated securely in the body.
Fit the steering wheel into the top of the front wheel assembly.
Ensure that the bolt is attached to the steering wheel as shown.
Align the steering wheel with the smaller front wheels, so that the wide end of the steering wheel
faces forward.
Note: When the front wheels are assembled and resting on a flat surface, the smaller front wheels
do not contact the ground.
Use a 20mm socket wrench (not included) to tighten the nut in the steering wheel column AS TIGHT
AS POSSIBLE. Fit the wrench onto the nut and turn until very tight.
Push the cap into the steering wheel.
TROUBLESHOOTING:
The rear wheels may detach from their housing if the ride on swing car is subjected to overloading or
impact. Fit the wheel into their housing so that the flat sides of the white clips contact the wheel
housing. Snap the wheel back into place.
If the steering wheel becomes locked or fails to propel the ride on swing car, the steering nut may
not have been tightened enough during assembly. Remove the cap from the steering wheel with a
screwdriver (not included) and loosen the nut with the socket wrench. Repeat steps 7 and 8,
securing the nut as tightly as possible. Then add the steering wheel cap.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Lenoxx 8821 Instructions Manual

Lenoxx
Brand
Lenoxx
Model
8821
Type
Instructions Manual

Lenoxx 8821

The Lenoxx 8821 is a ride-on swing car designed for children aged 3-6 years. It is suitable for both indoor and outdoor use and provides a fun and active way for kids to play. The car is made from durable materials and features a low center of gravity for stability. It does not require any batteries, gears, or pedals to operate, making it easy for kids to use.

To propel the car forward, children simply turn the steering wheel back and forth continuously. To go in reverse, they rotate the steering wheel 180 degrees. The car can be brought to a stop by simply stopping turning the wheel. It is important to note that adult supervision is required at all times when children are using the car. Children should wear protective equipment such as a helmet when riding the car.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents