INSTRUCTIONS
MULTIFUNCTIONAL LASER
DRILL GUIDE HOOVEX
PACKAGE CONTENTS
• Drill guide
• Dust cover
TECHNICAL SPECIFICATIONS
• Size: 250 × 95 × 50 mm
• Material: ABS
• Power supply: 2 × AA, 3 × 1.5 V button
battery (not included)
• Laser range: 5 m
• Wavelength: 650 nm
• Max. drill bit size: 10 mm
COMPONENTS
1. Laser
2. Levels
3. Laser switch
4. Suction release
5. AA battery compartment cover
6. Dust collector cover
7. Drill hole
8. ON/OFF switch
9. Suction cup
10. Button battery compartment cover
11. Dust cover
HOW TO USE
• Open the AA battery cover by twisting it
clockwise (as indicated by the diagram on
the cover) and insert two AA batteries.
Mind the polarity.
• Flip the drill guide over and remove the
button battery compartment cover. Insert 3
1.5 V button batteries and close it.
• To use the device, turn it on by using the
ON/OFF switch on the side.
• Use the laser switch to turn the laser ON or
OFF.
• Position the drill guide onto a flat surface
and press it down to engage the suction. It
will stick to any flat surface. Press the
suction release button on the side of the
device to release it.
• The dust collected from drilling will be
collected in the compartment around the
drill hole. Press on the sides of the
compartment to open it and empty it.
WARNINGS
• Only use the product for its intended
purpose.
• Do not disassemble or modify in any way.
• Keep away from heat and moisture.
• Keep out of reach of children and animals.
• Make sure to only use the tool in a well-lit
and secure environment.
• Use protective equipment such as gloves
and eye protection.
