2. Computers & electronics
  3. Computer cables
  4. Signal cables
  5. Deltech Fitness
  6. DF1200

Deltech Fitness DF1200 User manual

  • Hello! I've reviewed the assembly manual for the DELTECH FITNESS Lat attachment DF1200. This document contains detailed instructions for installing the pulley system, frame, cable, and weight carriage. I'm ready to answer your questions about the assembly process and the device's components.
  • What should I do if I am missing hardware?
    What should I do if I have any fit up problems?
    What parts are needed to install the pulley assembly?
*NOTE IF YOU ARE MISSING HARDWARE OR HAVE ANY FIT UP PROBLEMS PLEASE CONTACT DELTECH FITNESS TOLL FREE (888) 258-0533
FOR YOUR SAFETY READ ALL INSTRUCTIONS CAREFULLY
(888) 258-0533
DF1200
LAT ATTACHMENT
Assembly Manual
Assembly Video Available
Simply scan the QR code below
on your phone’s camera to access
the video
BOX CONTENTS
*NOTE IF YOU ARE MISSING HARDWARE OR HAVE ANY FIT UP PROBLEMS PLEASE CONTACT DELTECH FITNESS TOLL FREE (888) 258-0533
FOR YOUR SAFETY READ ALL INSTRUCTIONS CAREFULLY
CABLE
QTY 1
C
LAT BAR
QTY 1
D
WEIGHT CARRIAGE
QTY 1
E
PULLEY ASSEMBLY
QTY 1
A
ROUND CAP
QTY 2
F
SNAP HOOK
QTY 2
G
M12 WASHER
QTY 4
I
FRAME TUBE
QTY 1
B
M12 NUT
QTY 2
J
M12 x 75MM BOLT
QTY 2
H
INSTALL PULLEY ASSEMBLY (A) TO THE FRAME TUBE (B) USING M12 x 75MM BOLTS (H), M12
WASHERS (I), AND M12 NUTS (J).
NEXT SLIDE THE WEIGHT CARRIAGE (E) ONTO THE FRAME TUBE (B). INSTALL ROUND CAPS
(F) INTO WEIGHT TUBE ON WEIGHT CARRIAGE (E).
WEIGHT CARRIAGE INSTALLATION
J I
A
I
H
B
E
F
G
G
C
D
INSTALL THE CABLE (C) STARTING WITH THE END WITHOUT THE BALL-STOP THROUGH THE
TOP OF THE BODY ASSEMBLY MAKING SURE TO INSERT THE CABLE BETWEEN THE PULLEY
AND STOP BRACKET. RUN THE CABLE OVER BOTH PULLEYS AND DOWN TO WEIGHT CAR-
RIAGE ASSEMBLY.
INSTALL SNAP HOOKS (G) TO EACH END OF THE CABLE AND CONNECT TO LAT BAR (D) AND
WEIGHT CARRIAGE.
MAKE SURE ALL THE BOLTS ARE TIGHT BEFORE USE. REMEMBER TO CHECK THEM PERIODICALLY TO MAKE
CABLE INSTALLATION
/