AF1 Motorsports products are designed to best fit user’s ATV/UTV under stock conditions. Adding, modifying, or fabricating any factory
or aftermarket parts will void any warranty provided by AF1 Motorsports and is not recommended. AF1 Motorsports products could
interfere with other aftermarket accessories. If user has aftermarket products on machine, contact AF1 Motorsports to verify that they
will work together. Although AF1 Motorsports has thousands of satisfied customers, user should be aware that installing bumpers, rock
sliders, spare tire carriers, etc. will change the ride of machine and may increase maintenance and part wear. Operating any off-road
machine while, or after, consuming alcohol and/or drugs increases risk of bodily harm or death. No warranty or representation is made
as to this product’s ability to protect user from severe injury or death. AF1 Motorsports urges operators and occupants to wear a helmet
and appropriate riding gear at all times. By purchasing and installing AF1 Motorsports products, user agrees that should damages
occur, AF1 Motorsports will not be held responsible for loss of time, use, labor fees, replacement parts, or freight charges. AF1
Motorsports, nor any 3rd party, will not be held responsible for any direct, indirect, incidental, special, or consequential damages that
result from any product purchased from AF1 Motorsports. The total liability of seller to user for all damages, losses, and causes of
action, if any, shall not exceed the total purchase price paid for the product that gave rise to the claim. AF1 Motorsports will warranty
only parts provided by AF1 Motorsports. Any damage or problems with OEM housings, bearings, seals, or other manufacturers’
products will not be covered by AF1 Motorsports. AF1 Motorsports parts and products are not warrantied if item was not installed
properly, misused, or modified.
Liability Statement
Pass the 3/8” bolt through the rock slider and the wedge
anchor.
Wedge
Anchor “B”
3/8” Bolt
Wedge
Anchor “A”
Rock Slider
loosley thread the bolt onto the wedge anchor and repeat
for the remaining mounting holes in the Rock Slider
(8x) 3/8” x 4” Scew
(8x) End Caps
BED EXTENSION
FOR POLARIS RANGER 2021
HOW TO INSTALL
3
FOR PURCHASING AT AFX MOTORSPORTS
Press inward on the rock slider and tightening the bolts to
secure the rock slider ensuring each anchor assambly is fully
seated.
Mounting Holes
(1x) LEFT ROCK SLIDER
(PILOT)
(1x) RIGHT ROCK SLIDER
(CO-PILOT)
3/4” Combination Wrench
Align the anchor assemblies with the 4 mounting holes in the
vehicle chasis.
(8x) WEDGE
ANCHOR “A”
(8x) WEDGE
ANCHOR “B”
Hardware:
