Treadmill Belt

JLL Fitness Treadmill Belt Operating instructions

Hello! I have reviewed the instruction guide for treadmill belt adjustments. This document provides detailed steps for tightening and aligning your treadmill belt. I'm ready to help with any questions you have about the process or other information covered in the guide.
How do I test if my treadmill belt is loose?

What tool do I need to adjust the treadmill belt?

How do I tighten the treadmill belt?

How do I align the treadmill belt?

INSTRUCTION GUIDE

TREADMILL BELT ADJUSTMENTS

The contents of this manual are subject to change without notice to improve quality.

© 2023 JLL Fitness Ltd

JLL Fitness Ltd owns the copyright for this manual.

Use or reproduction of this manual in parts or entirety without the authorization of JLL Fitness Ltd is prohibited.

COPYRIGHT

CONTENTS

- Belt Tightening

- Belt Alignment

- Contact details

p. 4

p. 6

p. 7

4

When running on your treadmill you may feel a slipping sensation indicating your belt is not tight enough.

To test if your belt is loose you can:

• Stand with your feet on either side of the treadmill

• Set the speed to 1-2 km/h

• Try to stop the belt with your foot while holding onto the handrails

Please follow the steps below for how to tighten your running belt:

TOOLS

To make these adjustments you will need the allen key from your

tool pack.

BELT TIGHTENING

5

STEP 2

STEP 1

Using your allen key turn the bolts at the end of the treadmill deck

a quarter each time to the right.

To keep the belt aligned repeat the same amount of turns on each

side.

Tighten the belt a quarter at a time to prevent over-stretching the

belt.

Once tightened, test the belt again following the same process

described on pg. 4.

Start by turning off the power supply to the treadmill.

6

BELT ALIGNMENT

The gap between the belt and the frame should 5-6mm, if it’s not follow the steps below:

STEP 2

STEP 1

Using the allen key adjust the same bolts at the end of the deck as

before. If the belt is aligned to the left, adjust the left bolt clockwise

or adjust the right bolt counter-clockwise.

Visa versa if the belt is aligned to the right.

It’s advisable to leave your machine running at approx 6 km/h for a

few minutes to make sure the belt stays in line.

Start by setting the speed of the treadmill to 2-3 km/h.

7

CONTACT DETAILS

Tel: 0121 328 7507

Email: info@jlltness.co.uk

Live Chat: WWW.JLLFITNESS.CO.UK

For any technical queries, product defects or damage or delivery questions please contact us using the details below:

JLLFITNESS

/

Other documents