Ortech DMD-ELV User manual

Brand: Ortech

Model: DMD-ELV

Type: User manual

WARNING

Dimmers

MODEL DMD-ELV

PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.

Electrical products can cause death or injury, or damage to property.

If in any doubt about the installation or use of this product, consult a competent electrician.

INSTALLATION GUIDE

WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.

1. Use copper wire ONLY

2. Dimmers can only be installed by a qualified electrician

3. Turn OFF power at circuit breaker or fuse before wiring

4. Please keep the dimmers away from any corrosive substance, and please use dry cloth when you clean it

Instruction Manual

1-888-543-6473

1-888-541-6474

13376 Comber Way

Surrey BC V3W 5V9

[email protected]

www.ortechindustries.com

375 Admiral Blvd

Mississauga, ON L5T 2N1

Application Notice

1. Only 3-way switch can be used with 3-way dimmer

2. This product needs a neutral wire in the wallbox. For supply connector, use wires rated for at least +90ºC

3. Use ONLY to control the primary side of electronic transformer supplied low voltage lighting, or dimmable LED / CFL lamps

DO NOT

CAUTION

1. Turning power OFF

2. Simply turn the power OFF.

2. Wiring the Dimmer

2. Single-pole Wiring

2. Wiring the Dimmer

2. 3-way Wiring

2. Wiring the Dimmer

(See below diagrams)

3. Mounting Dimmer to Wallbox

2. Push wires carefully into the wallbox. Then, install the wall plate.

4. Turning power ON (simply turn the power ON)

ORTECH reserves the right to modify at any time, without notice,

any or all of our product's features, designs, components and

specifications to meet market changes.

Ortech DMD-ELV User manual

Ortech DMD-ELV User manual

Ortech DMD-ELV User manual

Related papers

Other documents