Quest Xpointer Oranje Pinpointer User manual

3“ ruler

Pinpoint p

Side scan area

Power buon

Tone/Vibraon

Speaker

Baery cap

Anchor loop

LED-Light

• Insert baery: Rotate the baery

cap counter clockwise, to open

the baery compartment. Insert a

new 9V baery (note polarity).

• Power on/o: Press and hold the

upper buon , unl you hear

a sound. Two sounds and the

LED-Light indicate, that the

pinpointer is ready to search.

• A metal object is signaled by

increasing sound and vibraon, the

nearer the pinpoint p and side

scan area get to it.

• Switch between tone+vibraon/

tone/vibraon by pressing the lower

buon mulple mes.

• Change the sensivity level by

holding the lower buon and

pressing the upper buon at

the same me. The sound indicates

the current sensivity level. 1 to

3 sounds = sensivity level 1 to 3,

permanent sound = level 4.

• If the XPointer has not been used for

3 minutes or the baery runs low, an

alarm tone is played.

• Keep the O-ring clean and greased.

INSTRUCTION MANUAL

ENG