Canopy Setup
QUICK SETUP INSTRUCTIONS ONLY!
Refer to the original owner's manual for complete use, care and safety information.
WARNING:
Never set up or continue to use in rain, wind, or storm conditions, especially lightning storms.
1 OPEN THE CANOPY FRAME
With a person on each corner, lift and partially
pull the canopy frame apart.
2 LOCK THE CANOPY FRAME
Push the roof locking mechanism upward while
holding the leg down. A snap button will engage in
the locating hole. Repeat on all corners.
3 ATTACH CANOPY FABRIC
Unfold the canopy top and place on top of the
canopy frame.
Secure the canopy top to the frame using the
hook and loop fastener connections.
4 ADJUST THE CANOPY HEIGHT
Press the red button on each leg to raise/lower the
canopy height. A snap button will engage in the
locating hole. Repeat on all corners.
5 ANCHOR THE CANOPY
Insert a stake through each foot of the canopy.
Attach one end of each rope to each corner of the
canopy fabric.
Tie the ropes to the stakes and insert the stakes
into the ground at a 45° angle.
