2. PYLO
  3. 802-LTE
802-LTE

PYLO 802-LTE User guide

  • Hello! I've reviewed the Quick-Start Guide for the Pyla PYLO 802-LTE Blood Pressure Monitor. This document explains how to set up the device, including inserting batteries, pairing, and using the cuff for measurements. I'm ready to answer your questions about the device's features and usage based on the instructions provided.
  • How many batteries are needed?
    What happens if the connection fails?
    Which port should I use for the cuff?
Quick-Start Guide
LTE Blood Pressure Monitor
PYLO 802-LTE
3
Secure Pairing Succesful
4
1Insert the 4 included AA
batteries into the device.
Once inserted, the
device will initiate an
initial secure pairing with
the mobile network.
2
Pairing in progress
While pairing, the symbols
and will be shown.
This process normally
takes around 10 seconds,
but may take up to a
minute if signal is weak.
When pairing is completed
successfully, the device
will display the symbol
and the screen will turn off.
The device is now ready to
use!
Plug the cuff tube into the
device.
Be sure to use the port
labeled 'Cuff Port' and
not the port for the
optional power adapter.
Wrap the cuff around your
arm and position it before
tightening.
Be sure to read and follow
the "How to Take Your BP"
guide that was included
with your monitor.
Press the "START/STOP”
button to turn on the
monitor. The cuff will
inflate, take a reading
and then deflate.
Remain still until the cuff
deflates completely.
Your results will be
displayed and saved to
the device prior to
transmission starting.
2~3cm
5
6
7
8
9
During data transmission`
the symbol will flash.
This process normally
takes around 10 seconds
but may take longer when
signal weak.
If the transmission is a
success, is shown.
If connection fails, E5 or
E6 is displayed. In this case,
the measurement is saved
and will be sent on the next
succesful connection.
For more information, see the full instruction manual.
Transmission Successful
/