Barco service bulletin
Serial Number: InfoT 615
Date: 28/06/2005
Product: iQ Reality +
Priority code*: D
A.
”Must” modification, Barco will provide t he necessary components to per form this mo difica tion
at no charge.
B.
Improves the reliability of the product.
C.
Improves the general working conditions of the product.
D.
For information only.
1. SOFTWARE V2.10 OVERVIEW
Overview
• Bugfixes and new functionality
1.1 Bugfixes and new functionality
Overview
• Double buffering: Double buffering is enabled by defau lt for sources with a pixel rate
below 170Mhz. This solves the image tearing problem.
• Vertical stripes sett
ings: reduces the vertical stripes issue.
• Single Board Computer : Lamps are only switched off when the SBC is off, allowing shut
down progress of SBC to be visible.
One can always switch to the SBC source to see the status of the SBC shutdown.
• White uniformity: White uniformity level adjustment range is increased.
• Fan Volta ge review for iQ Pro p rojectors (standby) for noise reduction :
a)Fangroup1->onwithvalue0i
f SBC is on and the projector is in standby
b)Fan group 5 -> on with value 0 if projector is in standby.
• New standard files added: SXGA+ (1400x1050@60)
Make sure a laptop immediatel
y gives image when it is started up: sometimes one has
to select via the
menu the corr ect source. Reason was : data on the gre en input was seen as sync o n
green if there was
no vertical sync present.
• Logo storage: Logo storage “rubbish” in the last columns solved.
• Serial number is expanded to 1
0digits
• Programming of DVI E2Prom: The E2Prom of a DVI input port is rewritten depending
on the panel resolution.
XGA and SXGA : file with version 1.2 is written.
SXGA+ : file with version 1.3 is written.
Barco nv Presentations
Noordlaan 5,
8520 Kuurne
www.barco.com
Page 1 of 2
Barco service bulletin
New/adapted RS232 commands
• Force lamp start up: If this command with the optional field is given once, the projector
will store a flag in the projector data. The next time the projector starts up, lamp 1 will
be used by default even if an lamp error occurred. This flag will be reset if the projector
is set in dual lamp mode using the RS232 command or forced in single lamp mode using
the OSD menu (service).
• Possibility to remove logo storage through serial command. All references to logo a re
removed fro m the
menu and all logo functionality is disabled.
InfoT:
InfoT 615
Page 2 of 2
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Barco iCon H600 Owner's manual
-
-
Barco iQ Pro R500 Owner's manual
-
-
Barco iQ G350 Owner's manual
-
-
-
Barco CLM R10 Owner's manual
-
-