Eltax Concept 400 User manual

Brand: Eltax

Model: Concept 400

Type: User manual

Eltax Concept 400 is a high-quality loudspeaker system designed to provide an exceptional listening experience for music lovers. With its advanced technology and meticulous engineering, the Concept 400 delivers pristine sound reproduction, bringing your favorite music to life with remarkable clarity and detail.

The Concept 400 features a robust construction with a rigid cabinet that minimizes unwanted resonances and vibrations, ensuring a clean and accurate soundstage. The advanced drivers, including a powerful woofer and a precise tweeter, work in perfect harmony to deliver a wide frequency response, capturing every nuance and subtle detail of your music.

Page is loading ...

Thank you for purchasing Eltax loud-

speakers. You have just purchased one

of the best domestic hi loudspeakers

available and we hope you will enjoy

the music they reproduce for many years

to come. The following notes are desig-

ned to assist you in obtaining a greater

degree of musical satisfaction from your

Eltax loudspeakers. Before connecting

your loudspeakers, we suggest that you

read this leaets carefully.

Amplier capacity - power handling

Your Eltax loudspeaker system will ope-

rate satisfactorily with any good amplier

designed for use with an 4-8 Ohm impe-

dance load. Although Eltax loudspeakers

are designed to handle high power loa-

dings, you must remember that any lou-

dspeaker that is abused with excessive

use of volume, tone controls and graphic

equalisers is likely to cause damage to

the drive-units. Be careful especially with

small ampliers constantly driven on high

power levels as these may be liable to go

into „clipping mode“ and distort the signal

causing possible damage. If you hear a

distorted signal through the loudspeakers

you must reduce the power level.

Connecting to your amplier

Some of the Eltax loudspeakers are sup-

plied with cables, however we strongly

recommend the use of high quality multi

strand speaker cables, colour coded or

grooved cables are recommended to

assist checking polarity, your local dealer

should be able to advise you on this

point. Always switch OFF your amplier

before making any connections or adjust-

ments to the system. Wire the right-hand

channel cable so that the positive (RED)

terminal of your loudspeaker is con-

nected to the positive (RED) on your

amplier, and the negative (BLACK) ter-

minal of your loudspeaker is connected

to the negative (BLACK) terminal on your

amplier. Repeat the instructions for the

left-hand channel. Do NOT connect more

than one loudspeaker to one terminal on

your amplier.

Phasing

Providing that you have followed the

connecting instruction correctly the loud-

speakers should be in phase and provide

solid stereo images. If however, you have

any doubt as to the phasing of the loud-

speakers, try reversing the connections

(RED & BLACK) to ONE of the loud-

speakers, and play a recording which has

plenty of deep bass operating both loud-

speakers simultaneously with the stereo

amplier switched to „mono“. The correct

polarity is indicated by rm full bass,

when incorrect, the bass will be notice-

ably much weaker.

Loudspeaker positioning

Ideally the Eltax loudspeakers should be

positioned at least 50 cm from a rear

wall, 1 meter from a side wall and at least

2 metres apart. The space between the

two loudspeakers and the distance form

the listeners are important. If loudspea-

kers are placed too close together or

too far apart, stereo images will not be

fully developed. In average living rooms,

speaker spacing between 2 and 4 metres

will usually produce satisfactory results.

The listeners distance from the loud-

speakers should be at least equal to and

preferably greater than the distance bet-

ween the loudspeakers. Tests should be

made with both speech and music before

deciding upon nal locations.

Service

No routine attention is required to the

working parts of the loudspeakers and

being very reliable Eltax loudspeakers

rarely require service. Any service pro-

blems should in the rst instance be

referred to your dealer.

Instruction manual

Page is loading ...

www.eltax.com

Eltax Denmark

Tel.: +45 97 47 23 11 • E-mail: inf[email protected]

Eltax Deutschland

Tel.: +49(0)461 28080 • E-mail: buro[email protected]

Eltax France

Tel.: +33 466 68 06 26 • E-mail: bureau.fr[email protected]

Eltax UK

Tel.: +44(0)1908 226464 • E-mail: of[email protected]

Eltax Service

Tel.: +45 96 41 15 99 • E-mail: ser[email protected]

Eltax Concept 400 User manual

Brand: Eltax

Model: Concept 400

Type: User manual

Download PDF

report

in other languages

italiano: Eltax Concept 400 Manuale utente
français: Eltax Concept 400 Manuel utilisateur
español: Eltax Concept 400 Manual de usuario
Deutsch: Eltax Concept 400 Benutzerhandbuch
dansk: Eltax Concept 400 Brugermanual

Eltax Concept 400 User manual

Eltax Concept 400 User manual

in other languages

Related papers

Other documents