Audioplex CAM IR-X4056 Installation guide

Brand: Audioplex

Model: CAM IR-X4056

Type: Installation guide

CAM IR-X4056 Outdoor IRTARGET

Used as a remote receiver and processor

SPECIFICATIONS:

INSTALLATION:

Connector: 3ft. black PVC cable w/pigtails.

Mounting: 3 Screw Holes in base, adjustable ball joint for aiming.

Remotes: Will handle almost all standard remote controllers (Note: does NOT work

with B & O equipment, which requires a proprietary confirmation talk-back

function).

Range: 110 feet indoors, 15 to 25 feet in direct sunlight.

Acceptance angle: + or - 25 degrees off center.

Wire: Uses conventional unshielded "zip" or telephone wire.

Power: 12 VDC @ 500 mA (unregulated (equals 15 volts), Included with packages)

Your IRTarget is designed to act as a remote receiver and processor of infrared signals.

This sensor will receive signals from remote controllers and send these signals to a remote

repeater. This allows remote operation of any unit from the room where the IRTarget is located.

CAUTION: Take care to make sure that the IRTarget installation is NOT IN THE LINE OF

SIGHT OR REFLECTION with the repeater. If radiation from the repeater is picked up by this

sensor, a feedback situation is created which will result in instability and unreliable operation.

Undesirable reflection can occur off of light colored walls, windows, mirrors, and even shiny wood

finishes! Also note that the wiring of the unit varies, depending on the type of infrared equipment

that is being used (see back of this page for wiring diagrams). Please call if you have any questions

about your installation.

Any standard type of wire can be used. Shielded or coaxial cable is not usually required

unless the wire passes through some unusually high electrical interference regions.

Prepare the wire leads to and from the IRTarget by stripping about 1/4" of insulation from

each of the ends. Twist strands tightly together so that none stick out to cause a possible short

circuit. OBSERVE POLARITY! The sensor will not function if the wires are not in order.

WARRANTY

Your AUDIOPLEX TECHNOLOGY IRTarget is covered by a Lifetime warranty against

defects in workmanship and materials. Any defects will be remedied without charge for labor or

parts.

Damage incurred by shipping or accident is not considered to be a defect, and not covered

by this warranty. AUDIOPLEX TECHNOLOGY is not responsible for defective operation caused

by abuse or by modification or service by an unauthorized person or agency.

The unit must be properly installed and operated according to instructions for the

warranty to apply. Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY. The

products must be returned expences prepaid, with written authorization from the company. The

unit must be shipped with the proof of purchase and in the original carton and packing material to

avoid damage.

TECHNOLOGY

INSTALLATION MANUAL

(Patent Pending)

2003 - 7/22/03

WIRING DIAGRAMS

(NOTE: 12 volt power supply and IRBug/IRFlood are supplied with IRTarget packages only)

AUDIOPLEX TECHNOLOGY

404 GWH P.O. BOX 440

MELVIN VILLAGE, N.H. 03850

1-800-257-2077 IN N.H. 1-603-544-8601

FAX: 1-603-544-8901

IRBug/IRFlood or

Emitter Plate

12 VDC Audioplex

UNREGULATED

POWER SUPPLY

BARE WIRE (GD)

YELLOW SIGNAL

RED 15V (B+)

FOR INSTALLATIONS USING AUDIOPLEX TECHNOLOGY INFRARED EQUIPMENT

NILES is a registered trademark of Niles Audio Corporation, Inc.

XANTECH is a registered trademark of Xantech Corporation.

2003 - 7/22/03

TEST

out to emitters

12 vdc system status(optional)

1/8" test input connector

UNREGULATED

12 vdc power supply

ROOM 2ROOM 3

ROOM 4ROOM 5ROOM 6

YELLOW SIGNAL

BARE WIRE

RED

GROUND (GD)

15V (B+)

IRStation (Back View)

Note for Rev B Only!

IRStation (Front View)

In-wall version shown, chassis version also available

Termination Block

IR-TB

Using IRStation Rev B / IRZ-1 / NIles / Xantech Connector Blocks

CAM IR Target

Audioplex CAM IR-X4056 Installation guide

Audioplex CAM IR-X4056 Installation guide

Audioplex CAM IR-X4056 Installation guide

Related papers