AOR LN4000 is a high-performance, low-noise wide-band preamplifier for 100MHz to 3000MHz. It can be used with scanner receivers, frequency counters, and spectrum analyzers. The LN4000 has a gain of 20dB±2dB and a noise figure of 4.5dB. It is powered by 5.0 to 12VDC and consumes approximately 26mA at 8VDC. The LN4000 comes with two BNC-SMA adapters, two coaxial cables with SMA-P connectors, and a DC power cable. It is recommended to use the LN4000 with an appropriate band-pass filter or notch filter to reject nearby strong signals.
AOR LN4000 is a high-performance, low-noise wide-band preamplifier for 100MHz to 3000MHz. It can be used with scanner receivers, frequency counters, and spectrum analyzers. The LN4000 has a gain of 20dB±2dB and a noise figure of 4.5dB. It is powered by 5.0 to 12VDC and consumes approximately 26mA at 8VDC. The LN4000 comes with two BNC-SMA adapters, two coaxial cables with SMA-P connectors, and a DC power cable. It is recommended to use the LN4000 with an appropriate band-pass filter or notch filter to reject nearby strong signals.
AOR LN4000 is a high-performance, low-noise wide-band preamplifier for 100MHz to 3000MHz. It can be used with scanner receivers, frequency counters, and spectrum analyzers. The LN4000 has a gain of 20dB±2dB and a noise figure of 4.5dB. It is powered by 5.0 to 12VDC and consumes approximately 26mA at 8VDC. The LN4000 comes with two BNC-SMA adapters, two coaxial cables with SMA-P connectors, and a DC power cable. It is recommended to use the LN4000 with an appropriate band-pass filter or notch filter to reject nearby strong signals.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI