Guardian 10K Straight Loop Insert Operating instructions

Brand: Guardian

Model: 10K Straight Loop Insert

Type: Operating instructions

STRAIGHT LOOP INSERT

INSTALLATION GUIDELINES

GF Protection, Inc. / 6305 South 231st Street, Kent, WA 98032 / 1.800.466.6385 / www.guardianfall.com

Section View:

*Note: Avoid kicking or knocking over installed Straight Loop Inserts while working. It is recommended that

inserts are fastened to rebar by wire tie or equivalent method for additional support.

9”

min from any edge

8” min

*Minimum of 3000-psi concrete

Insert bolt end of

anchorage assembly

from step 2 into Part

D. Ensure hex socket

on Part C mates

with bolt head of

Part E. Hand tighten

by rotating Part A

and applying

pressure towards

decking. Do not

over tighten to

prevent stripping

out decking.

Assemble mounting

hardware over the

threaded axis as

shown. All other

components should

sit ush with each

other and be held in

place by Part J.

Firmly hold housing

ush to surface

while fully

tightening

mounting hardware

with drill. Do not

over tighten to

prevent stripping

out decking.

Choose installation

location. Surface

should be at and

free of debris. Place

housing orange side

down and hold

rmly. Insert

mounting hardware

into housing and

push until secure.

(A)Straight Loop Insert

(B )O-Ring

(C)Plastic

Bolt

(D)Housing

(E)Lag

Screw

(F)Spacer

(G)Metal

Washer

(H)Compression

Bushing

(I)Plastic

Washer

(J)Retaining

Washer

Assemble

anchorage assembly

as shown. Assembly

should be tightened

until Part B just

contacts Part A and

Part C but is not

compressed.

US Patent Pending

*Please refer to

Guardian’s 10K Swivel Manual for

instructions regarding fastening Swivel to

Straight Loop Insert.

Guardian 10K Straight Loop Insert Operating instructions

Guardian 10K Straight Loop Insert Operating instructions

Guardian 10K Straight Loop Insert Operating instructions

Related papers

Other documents