CMP-NWCARD11
10/100 LAN CARD
MANUAL
ANLEITUNG
MODE D’EMPLOI
GEBRUIKSAANWIJZING
MANUALE
MANUAL DE USO
HASZNÁLATI ÚTMUTATÓ
KÄYTTÖOHJE
BRUKSANVISNING
NÁVOD K POUŽITÍ
1
1. Card Installation
To insert the product into your computer, follow the steps listed below:
1. Turn off the computer and remove the cover;
2. Insert the LAN card into a free PCI slot;
3. Secure the LAN card to the computer chassis and put back the
cover;
4. Connect the LAN card to the network via the network cable.
2. Driver Installation
When the LAN card is not automatically supported by your OS please
install the drivers which come with the LAN card.
3. Troubleshooting
If you experience any problems with the adapter, first make sure the
appropriate driver is installed, the proper cable is connected and all
devices have the same specification such as 10Mpbs 10Base-T or
100Mbps 100Base-TX. Then recheck the LED status.
LINK/ACTIVE LED
A red LED indicates if the 10 or 100MBPS STP/UTP has been linked OK
and is working. When the light is OFF it indicates that the STP/UTP port
has not been connected or there is no link. When the light is ON it
indicates that the STP/UTP port is linked OK. When the light is blinking it
indicates that the STP/UTP port is receiving or transmitting data.
Safety precautions:
To reduce risk of electric shock, this product should ONLY be opened by an
authorized technician when service is required. Disconnect the product from
mains and other equipment if a problem should occur.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of
the product or damage caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
Copyright ©
English Deutsch Français Nederlands
Italiano Español Magyar Suomi Svenska Česky
/