... then play
(see next page)
not supplied
Component Video
S-VI EO D
IN
not supplied
3
2
1
ANTENNA IN
you will need an ac essory
If your TV has only a
single Antenna In jack,
c
RF modulator. The RF
modulator converts the video
from the DVD player so it can
play through the TV’s Antenna
connector. Refer to your owner’s
manual for proper connectio n
(see pag 10 in the owner’s
e
manual).
Helpful Hints
You only need to make one video conn tion to ec
your TV in order to view DVD playback.
If your TV has
this video input jack(s)
VID O E
IN
Use this
video cable(s)
supplied
OPTICAL
DIGITAL OUT
COAXIAL
Y
S-VIDEO
OUT
R
A
UDIO OUT
PrPb
1
VIDEO
OUT
L
3
2
Y
VIDEO IN
Pb/Cb
Y
Pb/Cb
S O-VIDE
AUDIOIN
IN
VIDEO IN
COMPONENTVIDEO IN
Pr/Cr
IN
Pr/Cr
AUDIO
IN
COMPONENT
VIDEO IN
S-VIDEO
IN
IN
First connect ...
DVP640 • DVP642
12nc: 8239 210 98311
Printed in China
Detailed playback features and additional functions are described in the
accompanying owner’s manual.
1
ALL
DVDs must be labeled for ALL regions or for
Region 1 in order to play on this DVD Player.
Region Codes
* Usually this channel is between the lowest and highest channels and
may be called FRONT, A/V IN, or VIDEO.
* Or, you may go to channel 1 on your TV, then press the Channel down
button repeatedly until you see the Video In channel.
* Or, your TV remote control may have a button or switch that chooses
different video modes.
* Do not use channel 3 or 4 on the TV unless you are using an RF
modulator.
* See your TV manual for more details.
Check the AV (Audio/Video) mode on your TV.
No picture?
To stop playback, press STOP 9.
Playback will start automatically.
If a disc menu appears, use 3 4 1 2 on the remote to make a selection, then
press OK to confirm. Or, use the numeric keypad on the remote to select
numbered features. Follow the instructions given in the disc menu.
5
4
MUTEPREVIEW
Make sure the disc label is facing up. For double-sided discs, the label of the
side to play should face up.
Press OPEN/CLOSE 0 on the front of the DVD Player and
load a disc. Press OPEN•CLOSE 0 again to close the disc
tray.
You should see the blue Philips DVD background screen on the TV (if no disc
is in the DVD Player).
Select the correct Video In mode at your TV.
Turn on the TV, then press STANDBY-ON 2 to turn on the
DVD Player.
3
2
1
Playing a disc
Make sure your DVD Player and
TV are connected and turned on!
LABEL
continue...
-
1
-
2
Philips DVP640 User manual
- Category
- DVD players
- Type
- User manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Magnavox MRD300/99 User manual
-
-
Sylvania CDVL100D User manual
-
Toshiba SD-K780KU User guide
-
-
Funai MSD126 User manual
-
Philco DP100MW8B A User manual
-
Vizio SD4200KU User manual
-
-