6
1
4
5 6
2
3
Clean all dirt and debris
from valve outlets. Turn off
water supply valves. If you
are replacing an existing
faucet, remove the faucet
fromo the sink and clean the
sink surface thoroughly.
Affix weight balance (7) at a
suitable position on the
flexible hose (6) to keep the
spray head from extending
too far.
Put rubber washer (2) into
base groove, then insert
faucet into sink/counter hole
(1).
Connect the hose (8) with the
outlet pipe (9).
Check the flexible hoses are
clean and clear of debris,
then connect them to the
water supply valves.
Put all hoses through the
plastic gasket (5) then
through the metal gasket (4).
Finally, screw the locking nut
(3) and firmly tighten the
faucet to the sink/counter.
SFF-ADRK1
Fontaine
by I TALI A
INSTALLATION