2. PSC
  3. Headphone Distribution Amp

PSC Headphone Distribution Amp User manual

  • Hello! I am an AI chatbot trained to assist you with the PSC Headphone Distribution Amp User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
PSC Headphone Distribution Amplifier
Instructions
1. Remove slide-out battery holder and insert a fresh 9V Alkaline battery, being careful to match the polarity to the
drawing inside the battery holder.
2. Slide the battery holder back into the rear of the unit until it clicks. For battery operation, set the front panel
power switch to “BATT”. The LED will light green with a good battery and will turn red when the battery is
getting low. Battery life is estimated at 7-10 hours.
3. For external powering, set the power switch to “EXT” and plug in an optional AC/DC adapter at 6-15 Volts, 100
mA or greater. The center pin is Positive.
4. Plug an audio signal into the “Input” jack on the back side of the unit with a standard ¼” stereo phono plug.
Now you can connect up to 4-headphones to the output jacks on the back and control the volume level
individually with the front panel volume controls.
END
/