Electro-Voice SxA100 Installation guide

Figure 1

Step 1.

Slide two zip ties into first Heatsink Guard, ribbed side of zip ties facing

inward (Fig. 1).

SxA100 Heatsink Guard

Assembly and Installation Instructions

Step 2.

Place first Heatsink Guard on top of heatsink with zip ties in place between

the fins as shown (Fig. 2).

Step 3.

Slide second guard onto bottom of heatsink, putting the first two zip ties

through the slots on the guard. Slide the ends of two other zip ties onto the

first zip ties. Pull tight and cut off excess lengths (Fig. 3).

Kit Includes:

Heatsink Guard (x2)

Zip Tie (x4)

WARNING! HEATSINK MAY BE HOT! DO

NOT ATTEMPT TO INSTALL HEATSINK

GUARDS WHILE UNIT IS PLUGGED IN.

Figure 2

Figure 3

Part Number 38110-082 Rev A

12000 Portland Avenue South, Burnsville, MN 55337

Phone:952/884-4051, Fax:952/884-0043

www.electrovoice.com



Cut 4 places

