Figure 1
Step 1.
Slide two zip ties into first Heatsink Guard, ribbed side of zip ties facing
inward (Fig. 1).
SxA100 Heatsink Guard
Assembly and Installation Instructions
Step 2.
Place first Heatsink Guard on top of heatsink with zip ties in place between
the fins as shown (Fig. 2).
Step 3.
Slide second guard onto bottom of heatsink, putting the first two zip ties
through the slots on the guard. Slide the ends of two other zip ties onto the
first zip ties. Pull tight and cut off excess lengths (Fig. 3).
Kit Includes:
Heatsink Guard (x2)
Zip Tie (x4)
WARNING! HEATSINK MAY BE HOT! DO
NOT ATTEMPT TO INSTALL HEATSINK
GUARDS WHILE UNIT IS PLUGGED IN.
Figure 2
Figure 3
© Telex Communications, Inc. 12/2001
Part Number 38110-082 Rev A
12000 Portland Avenue South, Burnsville, MN 55337
Phone:952/884-4051, Fax:952/884-0043
www.electrovoice.com
Cut 4 places
/
