WARNING:
All fittings must be installed by a competent
person, in accordance with current IEE wiring
regulations. If in doubt, consult a qualified
electrician.
Switch off the electrical supply at the mains
BEFORE installation and maintenance.
Suitable for Bathroom Zones 2, 3 and non
bathroom/dry areas. See diagram below.
NOT suitable for above baths (Zone 0) or Zone 1
nor for installation in Saunas, Steam Rooms
or Shower Cubicles.
DO NOT connect to a plug
and socket outlet.
Rated IP44 and suitable for indoor use only.
Do not fix to damp or conductive surfaces.
Site well away from curtains and fabrics.
Never cover the
mirror.
Switch off after use
Do not leave on for prolonged periods.
IMPORTANT! BEFORE YOU BEGIN
Inspect the product immediately upon receipt for
transit damage, missing parts or manufacturing
faults.
Handle the product with care and protect against
knocks to all sides and edges of the glass.
Fixings supplied are for use in solid walls, hollow or
stud walls will require specialist fixings available
from your hardware supplier
Make sure that you have all the tools you need to
complete the job (SEE BELOW)
Ensure there are no hidden pipes or cables in the
wall before drilling.
If drilling holes in ceramic tiles use a piece of
masking tape on the tile to stop the drill bit from
slipping.
AFTERCARE INSTRUCTIONS
Clean using a soft dry cloth only when turned off.
Never use cleaning agents or abrasive materials.
Do not allow moisture to come into contact with
the lamps.
CONTAINS:
1 x Mirror, 5 x screws and 5 x wall plugs
INSTALLATION INSTRUCTIONS
1. Switch off the electrical supply at the
mains before beginning
2. Using the template, mark the wall with
a pencil.
3. Ensure that the mirror is level and
check there are no hidden pipes or
cables before drilling.
4. Wearing suitable eye protection, drill 4
holes using a 6mm drill bit and fix the
wall plugs and screws in place leaving
the end of the screw head protruding
from the wall.
5. Make the electrical connections in
accordance with current IEE wiring
regulations. If in doubt consult your
electrician
6. Carefully hang the mirror
7. Switch on the mirror lights
TOOLS REQUIRED
LED MIRROR INSTALLATION INSTRUCTIONS
.
.
.
803024R-LED-AC
803036R-LED-AC
803048R-LED-AC
Step1 Mirror installation
1.Install the hanger by screws on wall, make sure the hanger is stable.
2.Hang the mirror on the hanger.
3.Connect the mirror power wire to local wire, L-L, N-N.
4.Check the touch switch and mirror lighting connection.
110 AC
Step2 Cleaning and care
Daily cleaning and care are required in order to keep the product cleaning and
properly working.
Clean it with alcohol and dry it with soft cloth.
Clean the product with mirror glass cleaner.
Don’t use acid cleaner.
Don’t clean with abrasive material, abrasive paper or knife.
Wiring
This product requires an earth connection.
COLOUR CODING:
L - Live = Black
N - Neutral = White
- Ground = Green
803024R-LED-AC
803036R-LED-AC
803048R-LED-AC
-
1
-
2
Roswell 803024R-LED-AC Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Howard Elliott 11212 Installation guide
-
Howard Elliott 2003 Installation guide
-
Unbranded 51271 User guide
-
LTL Home Products LI8370 Operating instructions
-
-
lighted IMPRESSIONS LI8936 Installation guide
-
-
-
lighted IMPRESSIONS LI5164 Installation guide
-
