Westbrass R214-20 Installation guide

Type
Installation guide
R214
WESTBRASS 2429 E. Olympic Blvd., Los Angeles, CA 90021
(213)-627-8441 (213) 627-2844 or[email protected] www.westbrass.com
INSTRUCTIONS:
1. Thoroughly clean around
drain opening in sink.
2. Apply 1/8” bead of sili-
cone around drain opening
approx. 1/2” from edge of
opening.
3. Remove nuts and wash-
ers and place sink strainer
body through opening.
4. From the underside of
rubber washer and then
the thin metal over large
threads. Then screw large
metal or plastic nut tightly
against the washers.
5. Complete the installation
by further tightening large
nut with nut wrench or us-
ing a screw driver and ham-
mer (see illustration) until
strainer is water-tight.
INSTRUCCIONES:
1. Limpie alrededor de la
abertura del caño del la-
vabo.
2. Aplique un cordón de
silicona alrededor del caño
aproximadamente 1/2 pul-
gada del borde.
3. Retire la tuercas y aran-
delas y coloque el cesto del
4. Desde abajo del frega-
dero, coloque primero la
arandela de goma y luego
la metálica en las roscas
grandes. Luego atornille la
tuerca grande ajustando
contra las arandelas.
5. Complete la instalación
ajustando la tuerca grande
con una llave inglesa o us-
ando un destornillador y un
martillo (vea la ilustración)
-
méticamente.
D214 Installation Instructions
  • Page 1 1

Westbrass R214-20 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages