Maytronics MyDolphin User Instructions



1



User’s instructions to use the WiFi communication module

with MyDolphin™ application features.

1‐“ContainsFCCID:WCH99956085W“.

2‐FCCStatement

ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,pursuantto

part15oftheFCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainstharmful

interferenceinaresidentialinstallation.Thisequipment

generates,usesandcanradiateradiofrequency

energyand,ifnotinstalledandusedinaccordancewiththeinstructions,maycauseharmfulinterferenceto

radiocommunications.However,thereisnoguaranteethatinterferencewillnotoccurinaparticular

installation.Ifthisequipmentdoescauseharmfulinterferencetoradioor

televisionreception,whichcanbe

determinedbyturningtheequipmentoffandon,theuserisencouragedtotrytocorrecttheinterferenceby

oneormoreofthefollowingmeasures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

Maytronicsisnotresponsibleforanyradioorcommunicationinterferencecausedbyusingotherthan

specifiedorrecommendedcablesandbatteryorbyunauthorizedchangesormodificationstothisequipment.

Changesormodificationsnotexpresslyapprovedbythemanufacturercouldvoidtheuser’sauthorityto

operatetheequipment.

Thisdevicecomplies

withpart15oftheFCCRules.Operationissubjecttothefollowingtwoconditions:

1.Thisdevicemaynotcauseharmfulinterference,and

2.Thisdevicemustacceptanyinterferencereceived,includinginterferencethatmaycauseundesired

operation.

3‐Useconditions

TheWiFicommunicationmoduleistobeincorporatedintheIoTPowersupply(Host)bytheGranteeandisnot

forsaletoanyotherthirdparties.

4‐Limitedmoduleprocedures

4.1‐themodulartransmitterdoesn'thaveitsownRFshielding

4.2‐themoduletransmitterhasWiFitransmission

protocols

4.3‐themodulartransmittergetspowerinternallyfromitspowersupplyusingalinear3.3Vregulator

4.4‐themoduletransmitterhasanantennaprintedonthePCB

4.5‐themodulartransmitterhasbeentestedinsideanauxiliarydevicethereforeitismatchingmodulelimited

approval



2



4.6‐themodulartransmitterislabeledwithFCCIDandasitisnotvisibletotheuser,thereisanexteriorlabel

including"ContainsFCCID:WCH99956085W"

4.7‐themoduletransmittercomplieswithanyapplicableRfexposurerequirements

4.8‐themoduletransmittercompliestopara.15part15.247

4.9‐Themoduleiscompletelytunedandtestedbeforeshipmenttothefactory.Theretheboardwherethe

moduleislocatedisscrewedinplacetotheinternalfrontpartofthehousingofthehostandconnectedtothe

hostmainboardforinputvoltagebyawiresharness.



5‐theWiFimoduletransmitterhasanintegratedantennaprintedonthePCBwith0dBiGain.

TheantennaispartoftheprintedtracesinthePCBGerberfiles.

Themoduledoesnothaveatune‐upprocedureandalltune‐upsarecontrolledatthefactory.Theproductis



completelytunedandtestedbeforeshipment.

6‐InanyconditionthemaximumdistancewhereRFexposureallowedlimitsaremetis1.8cmfromthemodule

unit.

Themoduleinstalledinsidethemobiledeviceisdesignedtobeusedsothattheradiatingstructureofthe

devicemaybeused

atadistanceof20cmfromthebodyoftheuser.Thepeakpowerdensityatadistanceof

20cmislessthanthe1mV/cm

2

Powerdensitylimit.

7‐TheantennaisprintedonthePCB‐seepara.5above.

8‐ThefollowinglabelshallbeattachedtotheoutersurfaceoftheHost:



9‐OperationsystemModes

whentheWiFimoduleisoperatingitisconnectedandadvertising.

whenthesystemstatesthattheWi

FimoduleandtheBLEmoduleareoperating,theBLEmoduleisconnected

andtheWiFimoduleispairedandconnected

10‐ThemodulartransmitterisONLYFCCauthorizedfortherulesaslistedontheGrant.

IfotherFCCrulesapplytothehostandarenotcoveredbythemodulargrant,thesearethehostmanufacturer

responsibility.



3



11‐Operation



“ContainsFCCID:WCH99956085W“.

 ProceedtoWiFipairingonyourSmartphone.

TheSmartphoneident ifiestherobotandinitiatesapairingsequence.

NowthestrongsignaltransmittercommunicatesremotelywiththepowersupplyviaBluetooth

®.



12‐OEMINTEGRATIONINSTRUCTIONS

ThismoduleisintendedonlyforMaytronic’sdevicesunderthefollowingconditions:



Themoduleisinstalledinthehostequipmentsuchthat20cmismaintainedbetweentheantennaandusers,

andthetransmittermodulemaynotbeco‐locatedwithanyothertransmitterorantennaunless

evaluated

usingtheFCCmulti‐transmitterprocedures.Themoduleshallbeonlyusedwiththeinternalon‐boardantenna

thathasbeenoriginallytestedandcertifiedwiththismodule.Externalantennasarenotsupported.Aslongas

these3conditionsabovearemet,furthertransmittertestwillnotberequired.



Maytronicsisresponsiblefortestingtheend‐productforanyadditionalcompliancerequirementsrequired

withthismoduleinstalled.



Maytronics MyDolphin User Instructions

Related papers