Haier LE43B7000 User manual

LE43B7000

Contents

-1-

1 Safety and warnings........................................................................................................ ..2-3

2

Introduction............................................................................................................... ......4

3

Installation............................................................................................................... ....... 5-9

4

Remote Controller......................................................................................................... .. 10

5

TV Operation.................................................................................................................. 11-14

6

Trouble shooting.............................................................................................................1 5

If you are going to clean the product,Unplug the TV,use

soft fabric,no water,never chemicals.

74W

PAL: BG

2 x 8W

00810 x291

108 cm

199

TV 48.25 MHz – 863.25 MHzFrequency

VGA x 1

1 x oiduA CP

Quick Set up Guide

Note:This product uses a panel consisting of sub pixels which require sophisticated technology to

produce. However, there may be a few bright or dark pixels on the screen. These pixels will have

no impact on the performance of the product.

INSTALLATION NOTES

Locate the TV in a room where light does not strike the screen directly. Total darkness or a reflection

on the screen can cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing.

Allow enough space between the TV and the wall to permit ventilation.

Please do not attempt to rotate the TV on the stand.

Avoid excessively warm locations to prevent possible damage to the cabinet or premature component

failure.

Use the four screws to fix the TV onto a wall mounting bracket (not included) via the four VESA standard

holes on the back of the television.

Finished.Attach the stand base set to the bottom

of the TV by firmly tightening the

supplied 4pcs black screws.

Wall Mounting Installation Guidelines

Stand Assemble Instruction

INSTALLATION

200.00

M6

HDMI1,HDMI2,VGA,PC AUDIO,RF.

YPb/Pr,VIDEO/L/R,USB1,USB2,HEADPHONE.

Note: VIDEO and YPbPr share one audio channel.

HDMI2

USB1

USB2

POWER

SOURCE MENU VOL- VOL+ CH- CH+ POWER

RF.

HDMI2

The actual power wire is subject to goods.

Y Yellow (Video)

HDMI2

USB1

USB2

（These models do not support）

11

Installation Guide

The First Time Setup screen will appear when the

TV is first switched on or reset to the factory

setting.

Press the ▼▲ buttons to navigate the menu and

buttons to change the settings. Select your

desired language, Home/Shop Mode to be

displayed on the menu.

▲

Home or Shop modes

When the unit is turn on for the very first time, it

will show Initialization set-up menu. After the

OSD language is set, the user can choose between

"shop mode" and "home mode".

When the screen shows the following setting menu

and the cursor stays on the "home mode" choice,

press to adjust, and "OK" to enter the menu.

Choose "OK" to enter the next prompt Auto

Tuning.

ATV

12

Fav

FAV

You can adjust the OSD Language, Aspect Ratio,

Blue Screen, Reset, Software Update(USB), Shop Mode,

CEC.

St and ard

The second item of the MENU is PICTURE MENU.

You can adjust picture effect and ECO mode here,

such as contrast,brightness,etc.

Press▼▲ to move,press to adjust.

▲

Note

1).There are three colors temperature modes

can be selected normal, warm, cool.

2) PC Setting is available in PC mode only

which can adjust Horizontal position, vertical

position, size and phase.

13

Shop Mode Off

CEC

14

ATTENTION:

1. USB HDD compatibility is not assured.

2. Some format video is not played for some file reason.

3. Haier will not bear any responsibility for saving

facility quality problem or date missing.

Source Lock:Lock the input source which you want.

Default Source:Set the default input source when

tuning on your TV.

Max Volume:Set max volume limited,this option

allows you to set the m

ax volume level.

Default Volume:Power on default volume,press the

button to

select the default volume.

Default Prog: Set the default input prog when tuning on

Key Lock:Lock the key button with TV.

Please press “MENU” button first,and press number

button “1001” to enter into Hotel mode, then press

sele

ct “On” or “Off”. “ ” button to

your TV.

Clear Lock :Recall the default settings in Hotel mode.

Export Settings:Exp

ort hotel settings to USB device.

Import Settings:Import hotel settings from USB device.

Picture Audio

Snow Noise

antenna position, direction

or connection

Inspection

Interfere

Noise

electronic equipment,car/

motorcycle,fluorescent light

Normal Picture

Mute

Volume(inspect wether the

mute function on the remote

control are started , or audio

system are correct or not)

No picture Mute

Power cord is not inserted

Power switch is not opened

Contrast and brightness/volume

setup

Press standby key on the remote

control for inspecting

No color Normal audio color control

Scramble

Normal audio

or weak

retune channel

No color

Noise

Audio system

Special Explanation：The accessories such as remote control is not belongs to the guarantee。

Normal audio

antenna position, direction

or connection

Trouble phenomenon

Ghost

TROUBLE SHOOTING

-14-

Haier LE43B7000 User manual

Haier LE43B7000 User manual

Related papers

Other documents