6
Disposal
2 Packaging material
The packaging materials are
environmentally friendly and
can be recycled. The plastic
components are identified by
markings, e.g. >PE<, >PS<,
etc. Please dispose of the
packaging materials in the
appropriate container at the
community waste disposal
facilities.
2 Old appliance
The symbol W on the
product or on its packaging
indicates that this product may
not be treated as household
waste. Instead it shall be
handed over to the applicable
collection point for the
recycling of electrical and
electronic equipment. By
ensuring this product is
disposed of correctly, you will
help prevent potential negative
consequences for the
environment and human
health, which could otherwise
be caused by inappropriate
waste handling of this product.
For more detailed information
about recycling of this
product, please contact your
local council office, your
household waste disposal
service or the John Lewis
store where you purchased
the product.
Using your kettle
Before using your new kettle
you should wipe it inside and
outside with a damp cloth due
to hygienic reasons.
Initial use
Place the base unit (K) on a
firm surface.
Plug the mains plug into a wall
socket.
3 If the mains cord is longer
than necessary it can be
wound up at the bottom of
the base unit (K).
Press button (
D
) down to open
the lid (
C
).
Fill with sufficient water to
make it visible on the water
level indicator (F), but not
higher than the max. mark.
Close the lid (C) until it
engages. The automatic switch
off can only function reliably if
this is done.
Place the kettle onto the
base (K).
Set the desired temperature
with the temperature
controller (J). For boiling
water, rotate the controller to
the right to the position .
Press the ON/OFF switch (H)
down, the pilot light (G) lights
up and the kettle starts to
heat up.
822_949_350 EWA6000JL.book Seite 6 Freitag, 4. Mai 2007 4:47 16