Viking P30FTSSS Installation guide

Type
Installation guide

This manual is also suitable for

F20701A EN
®
(040711)
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information,
call 1-888-VIKING1 (845-4641)
or visit the Viking Web site at
vikingrange.com
Viking Installation Guide
Professional & Designer Oven Accessory
Flush Mount Kit
2 3
Removing Existing Trim
Removing Existing Trim
Remove the existing side trim pieces from the oven. There should be one trim piece on each
side of the oven.
For Professional ovens, there will be a trim piece at the top and bottom of the oven that will
need to be removed. Also, on the Professional ovens, the door will need to be removed prior
to removing the lower vent trim and putting on the new trim.
NOTE: Keep the screws that are left after removing the existing side trim pieces. These
screws will be used to install the flush mount accessory trim pieces.
DDOE
Double Oven
VESO
Single Oven
54
Installing Flush Mount Trim
Installing Flush Mount Trim
After removing the existing side pieces, install the flush mount trim pieces to the oven.
1. Remove the protective plastic from the flush mount trim pieces.
2. Install the two flush mount trim pieces to the oven (see diagram).
3. For Professional ovens, install the top and bottom trim pieces (see diagram).
NOTE: Only Professional model ovens will require a top and bottom flush mount trim
piece.
NOTE: There will be a designated right and left hand side flush mount trim piece. Install
the corresponding trim piece on the correct side, as they are not interchangeable.
4. After installing the flush mount trim pieces, the oven can be installed in the cutout.
DDOE
Double Oven
VESO
Single Oven
76
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Viking P30FTSSS Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI