Bauknecht ETPV 6950 IN is a glass-ceramic cooktop designed for built-in installation. It features different sized cooking zones to accommodate various pot sizes and offers precise temperature control for efficient cooking. The residual heat indicators provide additional safety and energy-saving benefits.
Bauknecht ETPV 6950 IN is a glass-ceramic cooktop designed for built-in installation. It features different sized cooking zones to accommodate various pot sizes and offers precise temperature control for efficient cooking. The residual heat indicators provide additional safety and energy-saving benefits.
11
Operating instructions
Before using the glass ceramic hob
Installation
Electrical connections
Energy saving tips
Safeguarding the environment
General recommendations and precautions
Care and maintenance of the glass ceramic
cooktop
Troubleshooting guide
After-Sales Technical Service
12
Before using the glass ceramic hob
•
To ensure best use of your new
appliance, please read the
operating instructions carefully
and keep them at hand in case of
need.
Installation
Cooking hob
Fit the cooking hob in a
worktop of thickness 30 mm
- 50 mm
Do not place materials
between the hob and oven
(crosspieces, brackets, etc.).
The distance between the
bottom of the glass ceramic
hob and the cabinet or
separating panel must be at
least 25 mm.
If a column unit is to be
installed next to the hob, it
must be kept at least 100 mm
from the edge of the hob.
Make an opening in the worktop,
respecting the dimensions
indicated in the enclosed product
sheet.
Apply the seal supplied around
the hob (unless it has already
been fitted), after cleaning the
surface.
Important
In order to prevent overheating and
related damaging of the electronic
circuits:
Do not install the hob near a
dishwasher or washing
machine, so that the
electronic circuits do not
come into contact with
steam or moisture which
could damage them.
Make sure that the oven
(manufactured by us) has a
cooling fan to protect the
electronic parts
as much as
possible if the hob is
installed above it.
If the temperature of the electronic
circuits exceeds the maximum
permissible value, the hob will
automatically switch off; in this case,
wait a few minutes until the internal
temperature of the electronic
circuits reaches a tolerable level,
when the hob can be switched on
again.
When combining a 900 mm hob and
a 600 mm oven (which must be
manufactured by us and with cooling
fan), access to the bottom of the hob
must be prevented by interposing a
separator.
Do not forget to switch off the
hob. If you inadvertently
forget to do so, the hob has an
automatic switching off device
which is activated after 1 to 6
hours of operation, depending
on the cooking level selected.
13
Installation
Fitting
The glass ceramic hob is designed
for fitting in a worktop.
1.
Arrange the seal around the
entire edge of the hob.
2.
To fix the appliance in the
worktop, use the clips
supplied, securing them with
screws and taking into
account the thickness of the
worktop, as shown in the
figure.
14
Electrical connections
The electrical connection must be
made before connecting the
appliance to the mains. The appliance
must be installed by a qualified
technician aware of the current safety
and installation regulations.
Installation must be carried out in
compliance with the directives of the
local electricity company. Make sure
that the voltage specified on the
rating plate is the same as that in your
home. The appliance must be
earthed: only use wires (including the
earth wires) of the appropriate size.
The manufacturer declines any
liability for injury to persons or
animals and damage to property
resulting from failure to observe the
above instructions. For the electrical
connection use an HO5 RR-F type
cable according to the table below:
Power supply voltage
If the hob is already fitted with
a power cable, refer to the
diagram for connection to the
mains supply given on the
product sheet.
The appliance must be
connected to the mains by
means of a multi-pole
disconnecting switch with
minimum contact gap of 3 mm.
Important
: The power cable must
be long enough to allow the hob to
be removed from the worktop and
must be positioned so as to avoid
damage or overheating caused by
contact with the base.
Connection to the terminal board
Note
: The yellow/green earth
wire must be connected to the
terminal with the symbol
and be longer than the other wires.
Strip approx. 70 mm of
sheathing from the power cable
(
B
).
Strip approx. 10 mm of
sheathing from the wires.
Firstly, insert the cable through
the special opening in the
cover. Then insert the power
cable in the cable clamp and
connect the wires to the
terminal block as shown in the
diagram printed on the bottom
of the protection cover.
Secure the power cable
(B)
with the cable clamp.
Fit and secure the protection
cover (
A
) by screwing it to the
bottom part of the hob.
After carrying out the electrical
connection, fit the hob from
the top and hook it to the
support clips, as shown in the
figure.
Wires Quantity x
size
220-240 V ~
~
3 X 2.5 mm
2
220-240 V 3 + ~
~
4 X 2.5 mm
2
400 V 3N + ~
~
5 X 2.5 mm
2
400 V 2N + ~
~
4 X 2.5 mm
2
15
Energy saving tips
Safeguarding the environment
1. Packing
The packing material is 100%
recyclable and marked with the
recycling symbol ( ).
2. Electrical appliances
•
This appliance is marked in
compliance with European
Directive 2002/96/EC on Waste
Electrical and Electronic
Equipment (WEEE). By ensuring
the correct disposal of this
product, you can help prevent
potentially negative consequences
for the environment and the health
of persons.
•
The symbol on the
appliance or accompanying
documentation indicates that
this product should not be
treated as domestic waste but
must be taken to a suitable
collection centre for the
recycling of electrical and
electronic equipment. Disposal
must be carried out in
compliance with local
regulations on waste disposal.
•
For further information on the
treatment, recovery and
recycling of this appliance,
please contact your local office,
household waste disposal
service or the shop where you
purchased the product.
EC Declaration of
Conformity
•
These appliances are designed
for coming into contact with
food products and comply with
European Directive
89/109/EEC.
•
They are designed for use only
as cooking appliances. Any other
use (e.g. room heating) is
deemed improper and
potentially dangerous.
•
The appliances are designed,
manufactured and sold in
compliance with:
•
The safety requirements of
“Low Voltage” Directive
73/23/EEC.
•
The protection requirements of
“Electromagnetic compatibility”
EMC Directive 89/336/EEC.
•
The requirements of Directive
93/68/EEC.
•
Use pots and pans with
bottoms of the same width as
the cooking zone.
•
Only use flat-bottomed pots
and pans.
•
If possible, keep pot lids on
during cooking.
•
Cook vegetables, potatoes, etc.
with little water in order to
reduce cooking times.
•
Using a pressure-cooker will
allow you to further reduce
energy consumption and
cooking times.
NO!
16
General recommendations and precautions
•
Before carrying out any
maintenance on this appliance,
disconnect it from the electric
power supply.
•
Keep children away from the
appliances when they are in use
and when just switched off.
•
The appliances must only be
repaired or adjusted by a
specialised technician.
•
Make sure the electrical wires of
other appliances used near the
hob do not touch hot parts.
• Do not switch on the
hotplates/cooking zones
without pots or pans.
•
The hob has hotplates/cooking
zones of different widths. Use
pots with bottoms of the same
width as the hotplate/cooking
zone.
To avoid permanently
damaging the glass ceramic
top, do not use:
-
pots with bottoms that are
not perfectly flat;
-
metal pots with enamelled
bottoms
-
At the end of cooking, press
the button .
•
Do not use the hob as a work or
support surface.
•
Pay constant attention when
frying food, since the oil may
catch fire.
•
If the glass ceramic surface
breaks or cracks due to a violent
impact (falling objects, etc.) do
not use it; call the After-Sales
Technical Service immediately.
Do not place food wrapped in
aluminium foil, plastic containers
or rags on the hot cooking zones.
•
To avoid scratching the surface,
do not drag pans across the glass
ceramic.
•
Avoid spilling sugar and similar
substances on the hob. If
necessary, clean the hob
immediately, following the
cleaning and maintenance
instructions contained in this
manual.
If the hob is fitted with halogen
plates, do not stare at the lamps.
•
This appliance is not intended
for use by persons (including
children) with reduced physical,
sensory or mental abilities or
lack of experience and
knowledge, unless supervised or
given initial instruction
concerning use of the appliance
by those responsible for their
safety.
17
Care and maintenance of the glass ceramic cooktop
Troubleshooting guide
The hob does not work
• Did you press the control
buttons according to the
instructions given in the
section “Using the hob” of the
attached ”Product sheet”?
• Is there a power failure?
•Did you dry the hob
thoroughly after cleaning it?
The hob will automatically switch off if
a fault occurs. The fault will be
indicated by the letters “F“ and “L”
flashing on the corresponding display.
At the same time, a warning buzzer
will sound for 3 seconds every 30
seconds. The buzzer will go off after
15 minutes.
Important!
If you cannot turn the glass ceramic
hob off after using it, immediately
unplug it.
After-Sales Technical Service
Before contacting the After-
sales Technical Service
1.
Try to eliminate the problem
(consult the “Troubleshooting
guide”).
2.
Switch the appliance off, then
switch it on again to see if the
fault has been eliminated.
If the fault persists after the
above checks, contact the
nearest After-Sales Technical
Service.
Always specify:
•
a brief description of the fault,
•
the exact type and model of the
appliances,
•
the service number (the number
after the word “Service” on the
dataplate), located under the
hob or on the Product Sheet.
The service number is also given
in the warranty booklet,
•
your address and phone
number.
If any repairs are required, contact
an
After-Sales Technical Service
Centre
indicated in the warranty.
In the unlikely event that an
operation or repair is carried out by
an
unauthorised technician,
always request a statement of the
work carried out and demand the
use of
original spare parts
.
Failure to comply with these
instructions can compromise
the safety and quality of the
product
.
NEVER use high pressure water
or steam cleaners.
It is advisable
to clean the hob after every use,
when cool. In this way grime will
not accumulate and cleaning will be
easier.
•
Use a clean cloth, absorbent
paper and washing up liquid, or
specific products for cleaning
the glass ceramic top.
•
Remove any stubborn cooking
deposits with the scraper
supplied and specific products.
Remove any food scraps from
the glass ceramic top before
they become hard.
•
Foods with high sugar content
(toffee, fruit juice, jam, etc.)
that boil over while cooking or
spattered sugar stains must be
immediately removed using a
scraper.
•
Do not use abrasive products,
bleach, oven-cleaner spray or
steel wool.
It is advisable to periodically go
over the glass ceramic hob with
the special waxes available on the
market.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
Bauknecht ETPV 6950 IN is a glass-ceramic cooktop designed for built-in installation. It features different sized cooking zones to accommodate various pot sizes and offers precise temperature control for efficient cooking. The residual heat indicators provide additional safety and energy-saving benefits.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Whirlpool ETPI 6640 IN User guide
-
Whirlpool EDPT 6740 IN User guide
-
Whirlpool ETPI 6640 IN User guide
-
-
-
Whirlpool ETPV 9500 IN User guide
-
Whirlpool KTCH60X User guide
-
LADEN ETVS 5660/IN User guide
-
Whirlpool ETPV 6640 IN User guide
-
Other documents
-
Whirlpool AKM 992/IX User guide
-
Ignis AKL 7000/IX User guide
-
Whirlpool AKM 987/BA/01 User guide
-
Whirlpool AKM 330 IX User guide
-
-
-
Whirlpool AKT 860/BA User guide
-
Whirlpool AKT 970/IX User guide
-
-