DESCRIPTION
The ADJUSTABLE WORKSTATION SHELF is an improved and
updated version of the Hubbell Workplace Solutions accessory
shelf. Improvements include: (1) Fully adjustable mounting
bracket spacing. (2) Positive tilt adjustment.
(3) Reinforced shelf. (4) E-Z NUTTM insert & twist trak nuts allow
installation without sliding bracket in from top.
CAUTION
Maximum capacity not to exceed 50 lbs(22.5kg).
INSTALLATION
1. Install mounting angles at desired height on vertical
supports by inserting E-Z NUTTM into trak opening, finger
tightening to be sure E-Z NUTTM rotates to clamp bracket
to trak, and fully tightening bolt. Depending on applica-
INSTALLATION INSTRUCTIONS
ADJUSTABLE WORKSTATION SHELF
tion, angles may face outward (as shown in Fig.1) or
inward. Be sure brackets are at same height.
2. Assemble shelf brackets to OUTSIDE of mounting
angles (Fig.2). Depending on application, flanges may
face outward (as shown in Fig.2) or inward. Place lower
bolt in proper hole to achieve desired angle. Be sure
large washers are inserted between mounting angles and
shelf bracket. Tighten securely.
3. Loosen, but do not remove, trak nuts on tops of shelf
bracket flanges. Slide shelf onto brackets with trak nuts
inside lateral rails (Fig 3). Center shelf on workstation
and tighten bolts to clamp in place.
4. Install End Caps into ends of lateral rails (Fig. 4)
Printed in USA Bulletin No. 63010601.a
600 South Clark St.
Mayville, WI 53050
Phone 920–387–4120
HUBBELL
®
Workplace Solutions
Positive four
position shelf tilt.
Shelf held at
desired angle by
lower bolt in one of
four holes.
Lower bolt
Shelf
bracket
Large
washers
Lateral rails beneath
shelf allow side-to-side
bracket positioning. Insert End Caps into rails to
complete installation.
Completed installation.
Trak nuts affix
shelf to bracket. Figure 3
Figure 1 Figure 2
Figure 4
E-Z NUTTM rotates to clamp
bracket to vertical trak.
Vertical support
Shelf mounting
angle bracket
/
