NightStick LGL-ML2 User manual

Brand: NightStick

Model: LGL-ML2

Type: User manual

NightStick LGL-ML2 is a versatile and durable weapon light mounting kit that provides a secure and customizable platform for attaching your weapon light and accessories to your rifle. With its M-LOK compatibility, the LGL-ML2 can be easily installed on any M-LOK-compatible handguard, giving you the flexibility to position your light and accessories exactly where you need them.

The kit includes a variety of mounting options, including an offset mount for your weapon light, a pressure pad mount for your remote pressure switch, and a wire management clamp to keep your wires organized and out of the way. The LGL-ML2 is also backed by a 2-year warranty, which gives peace of mind and confidence in the reliability of this product.

Installing the M-LOK

Mounting Kit

Ensure the safety and security of your weapon

before changing the offset mount on the light.

INSTALL THE OFFSET MOUNT

yRemove existing Picatinny mount from the

weapon light with supplied Allen wrench. Discard

Allen screws.

yPosition mount on the rail where desired and install

using the included Torx screws and lock washers.

yLoosen M-LOK fasteners enough to allow the

toggle nuts to pass through rail slot.

yTighten each mounting screw, ensuring toggle nuts

turn 90 degrees against slot.

INSTALL REMOTE PRESSURE

SWITCH MOUNT

yRemove existing Picatinny remote pressure

switch that came with your LGL-Series weapon

light if needed.

yLoosen the M-LOK fasteners on the new

pressure pad mount (NS-PIC2) enough to allow

the toggle nuts to pass through the rail slot. Tighten

each mounting screw, ensuring toggle nuts turn 90

degrees against slot.

yThe pressure pad mount has a spring-loaded stop

to hold the RPS in place. To install the switch, push

down on the retention stop and slide the RPS fully

into place. The pressure pad mount allows the switch

to be installed in either direction, depending on your

conguration.

ATTACH WIRE MANAGEMENT CLAMP

yIf installed, remove existing Picatinny wire

management clamp. To install the new wire

management clamp (NS-WM2), rst separate the

cover from the base with the Torx wrench.

yLoosen both M-LOK fasteners on the base to allow

the toggle nuts to pass through rail slot. Tighten

each mounting screw, ensuring toggle nuts turn 90

degrees against slot.

yRoute the RPS wire through channels in the cover

depending on your conguration. Hold to ensure

wires stay in the channels while placing the cover

onto the base. Tighen cover screw. Note: If the cover

does not sit ush, check that the wire is properly set

into the channels.

y Tighten the Torx cover screw.

WARRANTY

2 YEAR WARRANTY

Bayco Products, Inc. warrants this product to be

free from defects in workmanship and materials to the

original purchaser for 2 year from the date of purchase,

and includes the LEDs, housing, lenses, electronics,

switches, rechargeable batteries and chargers. Bulbs

(other than LEDs) are covered for 90 days from the date

of purchase.

We will repair or replace this product should we

determine it to be defective. This is the only warranty,

expressed or implied, including any warranty of

merchantability or tness for a particular purpose.

For a complete copy of the warranty, go to www.

baycoproducts.com/nightstick-product-support/

warranties. Retain your receipt for proof of purchase.

Spring-loaded stop

Wire management

clamp cover

Bayco Products, Inc. • 640 South Sanden Blvd. Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com

INS-LGL-ML2-23

NightStick LGL-ML2 User manual