2. SMITH SYSTEM
  3. 179915

SMITH SYSTEM 179915 Assembly Instructions

  • Hello! I have reviewed the Assembly Instructions for the Elemental Nest and Fold Table. This document covers the steps for assembling the table including installing the legs, casters and leveling using shims. I am ready to answer any questions you have about the assembly process or features of this table.
  • What tools are required for assembly?
    How many people are needed for assembly?
    How do I level the table?
Form# 179915 02/2019
Assembly Instructions
Elemental
Nest and Fold Table
If you have damaged or missing components,
Please contact customer service at 1-800-328-1061
Form# 179915 02/2019
Hardware and Components
Form# 179915 02/2019
Special Notes:
x TOOLS REQUIRED:
• 3/16 INCH Allen Wrench.
• Caster Wrench.
x Check that all components are accounted for and undamaged before assembling.
x Please assemble the product in a clean and dry area.
x You will need another person to help assemble the product. Team lifting required.
x Clean the product with a mild cleaner and a damp cloth.
Form# 179915 02/2019
Assembly Instructions
1. TABLE LEG INSTALLATION.
a. Place the table on a flat clean surface and fold the center beam to access the
holes for machine bolts.
b. Secure the table legs using the supplied machine bolts. Each leg requires two
bolts.
c. NOTE: Adjustable height legs install with set screw, and hole pattern, facing toward
center of table.
Form# 179915 02/2019
2. CASTER INSTALLATION.
a. With the table in the upside down position, install the casters with the supplied
caster wrench.
Form# 179915 02/2019
.
3. LEVELING INSTRUCTIONS.
a. If table is not level, use the supplied shims in order to level the table.
b. Loosen the two counter sink screws as shown below and insert the supplied
shims. Do this on both mechanisms, not just one.
c. Retighten the screws and check the table. If the table is not to the desired
position, insert additional shims.
d. NOTE: table can be shimmed from front or rear, depending on desired effect.
/