Baxi Solo 3 30 PF Owner's manual

Brand: Baxi

Model: Solo 3 30 PF

Category: Fireplaces

Type: Owner's manual

User’s Operating

Instructions

Please keep these instructions safe.

Should you move house, please hand

them over to the next occupier.

Baxi Solo 3 PF

Wall Mounted Powered Flue

Gas Fired Central Heating Unit

Baxi UK Limited is one of the leading manufacturers

of domestic heating products in the UK.

Our first priority is to give a high quality service to our

customers. Quality is built into every Baxi product -

products which fulfil the demands and needs of

customers, offering choice, efficiency and reliability.

To keep ahead of changing trends, we have made a

commitment to develop new ideas using the

latest technology - with the aim of continuing to

make the products that customers want to buy.

Baxi is also the largest manufacturing partnership in

the country. Everyone who works at the company has

a commitment to quality because, as shareholders,

we know that satisfied customers mean continued

success.

We hope you get a satisfactory service from Baxi. If

not, please let us know.

Natural Gas

Baxi Solo 3 30 PF

G.C.No. 41 075 04

Baxi Solo 3 40 PF

G.C.No 41 075 05

Baxi Solo 3 50 PF

G.C.No. 41 075 06

Baxi Solo 3 60 PF

G.C.No 41 075 07

Baxi Solo 3 70 PF

G.C.No. 41 075 08

Baxi Solo 3 80 PF

G.C.No 41 075 09

Baxi is a BS-EN ISO 9001

Accredited Company

The boiler meets requirements of Statutory

Instrument “The Boiler (Efficiency) Regulations

1993 N

3083” and is deemed to meet the

requirements of Directive 92/42/EEC on the

efficiency requirements for new hot water boilers

fired with liquid or gaseous fuels:-

Type test for purpose of Regulation 5 certified by:

Notified Body 0086.

Product/Production certified by:

Notified Body 0086.

For GB / IE only.

1.0 Warnings

1 3

1.1 Safe Installation

1. This appliance must be installed in accordance

with the manufacturers instructions and the rules

in force. For Ireland install in accordance with

I.S.813 “I

NSTALLATION OF GAS APPLIANCES”. The

installation must be carried out by a CORGI

Registered Installer or other competent person

and be in accordance with the relevant

requirements of the current G

AS SAFETY

(Installation and Use) REGULATIONS, the BUILDING

REGULATIONS (Scotland) (Consolidation), the LOCAL

BUILDING REGULATIONS, the CURRENT I.E.E. WIRING

REGULATIONS and the bye laws of the Local Water

Undertaking. Where no specific instructions are

given, reference should be made to the relevant

BRITISH STANDARD CODES OF PRACTICE.

Read the instructions before installing or using this

appliance.

IMPORTANT: The addition of anything that

may interfere with the normal operation of the

appliance without the express written

permission of Baxi UK Limited, could invalidate

the appliance warranty and infringe the Gas

Safety (Installation & Use Regulations).

WARNING: Sealed components must not be

interfered with.

Never hang clothes or other items over the

appliance.

1.2 In case of gas leaks

1. If a gas leak is found or suspected, turn off

the gas supply at the meter immediately and

contact your Installer or Local Gas Supplier

Emergency Service (under 'Gas' in the phone

directory).

1.3 Servicing your boiler

1. We strongly recommend that your Boiler is

serviced annually by a competent person for

economic and safety reasons. Your Installer or

British Gas Service will be able to advise you.

1.4 Electricity supply

1. THIS APPLIANCE MUST BE EARTHED

A standard 230 volt ~ 50Hz supply is required.

The appliance must be protected by a 5 amp fuse.

“Benchmark” Installation, Commissioning and Service Record

Log Book

Please ensure that your installer has completed the Installation and

Commissioning sections of the Log Book and hands the Log Book over.

The details of the Log Book will be required in the event of any warranty

work. Keep the Log Book in a safe place and ensure that the relevant

sections are completed at each subsequent regular service visit.

WARNING: If it is either known or suspected that a fault exists on the

appliance, it must not be used until the fault has been corrected by a

competent person.

All CORGI registered installers carry a CORGI identification

card and have a registration number. Both should be recorded

in your boiler Log Book. You can check your installer is

registered by telephoning 01256 372300 or writing to:-

1 Elmwood,

Chineham Business Park,

Crockford Lane,

Basingstoke. RG24 8WG

2.0 Operating the Boiler

2.1 Operating the Boiler

1. Remove lower door panel as shown (Fig. 1).

2. Turn the boiler thermostat knob to the '0'

position fully anti-clockwise (Fig. 2).

3. Turn on the main gas and electricity supplies

to the appliance.

4. Set the thermostat control knob to the

required setting. (The optimum boiler setting

depends upon type of system, external controls

and your requirements. Your installer will be able

to advise you on this matter.)

5. The fan will start to run and after a short

period of time the ignition spark will commence.

Sparking will continue until the pilot flame is

established then stop automatically. The main

gas will then come on and the burner will light

from the pilot flame. Check that both the main

burner and the pilot are alight by looking through

the viewing window. The bottom four indicator

lights should also be illuminated (Fig. 3).

2.2 To shut down the boiler

1. Turn off the electricity supply to the appliance

at the mains.

2. Turn the thermostat knob to zero (Fig. 2) then

turn off the gas supply at either the appliance

gas cock or the meter.

2.3 Frost Protection

1. The appliance incorporates a frost protection

thermostat that will light the appliance when it's

temperature falls to near freezing. Note that this

is designed to protect the boiler only - the

system pipework may require the protection of

an additional stat.

2. To set the appliance to frost protection but

without normal heating. Set the control knob to

the

position (Fig. 2).

3. The frost protection will only operate if gas

and electrical supplies are switched on.

Your Baxi Solo is a gas fired, room sealed,

fan-assisted, central heating boiler providing

heating for your home and domestic hot

water where required.

THERMOSTAT KNOB

To shut down the boiler

turn fully anti-clockwise

Fig. 2

Fig. 3

Overheat

Boiler On

Fan On

Pilot On

Burner On

Overheat Neon

Warning

Fig. 1

3.0 Overheat Cut-Off Device

3.1 Overheat Cut-Off Device

1. Your boiler is fitted with an additional safety

device which shuts down the appliance should the

system overheat. The "overheat" indicator light will

be illuminated if the appliance needs resetting.

NOTE: Any interruption to the electricity supply

may cause the device to operate. In the case of

persistant operation of the device, turn off the

boiler and consult your service engineer as an

appliance or system fault is indicated.

3.2 Resetting

1. To reset the device follow these instructions.

2. Allow the boiler to cool if hot.

3. Remove the lower door panel by following the

sequence of diagrams (Fig. 4).

5. Turn the boiler thermostat control knob fully

anti-clockwise to the OFF position marked '0'

(Fig. 5).

6. Wait 10 seconds.

7. Turn the control knob clockwise to the required

thermostat setting, the overheat light will go out

and the boiler will commence sparking and fire up

automatically when the boiler has sufficiently

cooled (Fig. 6).

8. No adjustments to the gas controls or boiler

thermostat are required.

THERMOSTAT KNOB

Fig. 6Fig. 5

Overheat

Boiler On

Fan On

Pilot On

Burner On

Overheat Neon

Warning

Fig. 4

4.0 Clearances

4.1 Clearances around the boiler (Fig. 7)

1. The minimum clear spaces needed around the

boiler are:

Top: 50mm (2 in)

Bottom: 100mm (4 in)

Sides: 5mm (

in)

Front: 5mm (

in)

2. These clearances must not be obstructed in

any way. Blocking the clearance spaces will

result in the appliance overheating and

possible damage may occur.

3. The boiler may be installed in a cupboard if

these minimum clearances are kept. Note that the

label affixed to the front of the boiler must be left in

place to ensure future servicing is successfully

undertaken.

4. The compartment should be large enough to

house the boiler and ancillary equipment only.

5. IT SHOULD NOT BE USED AS A STORAGE

CUPBOARD.

6. The gas burning compartment of your boiler is

completely sealed from the room in which it is

fitted. Products from the combustion of gas are

vented to the outside through the flue terminal

which must be kept free from obstruction as this

would interfere with the correct operation of the

boiler.

300mm for servicing

5mm during operation

5mm5mm

350mm (30,40,50 models)

600mm

50mm

100mm

462mm (60,70,80 models)

Fig. 7

287mm

5.0 Cleaning, Spares & Guarantee

5.1 Cleaning the case

1. The painted panels should be wiped with a

damp cloth and then dried completely. DO NOT

USE ABRASIVE CLEANING AGENTS.

5.2 Spare Parts

1. Any repairs to the appliance will usually be the

responsibility of the Installer during the

guarantee period after which spare parts may be

obtained through approved Baxi stockists if

required.

2. Quote the appliance name, model number

and where possible the part number when

ordering spares. An abbreviated data plate with

this information is inside the removable door

(A parts list is included in the Installation and

Servicing Instructions.)

Only a CORGI registered or other competent

person should service this appliance.

5.3 Guarantee

1. Your Baxi Solo 3 is designed and produced to

meet all the relevant Standards and EU

directives.

2. Baxi UK Limited provide a 12 month

guarantee on the Boiler - other parts of the

system are covered by the Installer or other

manufacturers. The guarantee operates from the

date installation is completed for the customer

who is the original user.

3. To maximise the benefit from our guarantee

we urge you to return the reply-paid guarantee

registration.

4. This does not in any way prejudice your rights

at Common Law. Such rights between the

customer and the installer or supplier from whom

the unit was purchased remain intact.

Any component or part which becomes

defective during the guarantee period as a

result of faulty workmanship or material

whilst in normal use will be repaired or

replaced free of charge.

Baxi UK Limited

Brownedge Road

Bamber Bridge Preston

Lancashire

PR5 6SN

www.baxi.com

The Baxi Helplines

For General Enquiries

+44 (0)8706 060 780

For After Sales Service

+44 (0)8706 096 096

For Technical Enquiries

+44 (0)8706 049 049

Comp N

244097 - Iss 4 - 7/00

Baxi Solo 3 30 PF Owner's manual

Brand: Baxi

Model: Solo 3 30 PF

Category: Fireplaces

Type: Owner's manual

Download PDF

report

Baxi Solo 3 30 PF Owner's manual

Baxi Solo 3 30 PF Owner's manual

Related papers

Other documents