Page is loading ...
Page is loading ...
3
ENGLISH
English
Intended use
Your Black & Decker food processor has been designed for
preparing food and beverage ingredients as described in this
manual. Do not use this appliance for any other purpose.
This product is intended for household use only.
Safety instructions
Warning! When using mains-powered appliances, basic
safety precautions, including the following, should always be
followed to reduce the risk of fire, electric shock, personal
injury and material damage.
X Read all of this manual carefully before using the
appliance.
X The intended use is described in this manual. The use
of any accessory or attachment or the performance of
any operation with this appliance other than those
recommended in this instruction manual may present a
risk of personal injury.
X Retain this manual for future reference.
Using your appliance
X Make sure that the appliance is switched off before
connecting to or disconnecting from the power supply.
X Always take care when using the appliance.
X Do not use the appliance outdoors.
X Do not operate the appliance if your hands are wet.
X Do not operate the appliance if you are barefoot.
X Do not touch moving parts. Keep long hair and loose
clothing out of the way of the moving parts.
X Guide the power supply cord neatly so it does not hang
over the edge of a worktop and cannot be caught
accidentally or tripped over.
X Never pull the power supply cord to disconnect the plug
from the socket. Keep the power supply cord away from
heat, oil and sharp edges.
X Switch off and wait for the motor to stop running before
disconnecting the appliance from the power supply.
X Never detach any part or accessory while the appliance
is still connected to the power supply. Always
disconnect the appliance from the power supply first.
X If the power supply cord is damaged during use,
disconnect the appliance from the power supply
immediately. Do not touch the power supply cord before
disconnecting from the power supply.
X Disconnect the appliance from the power supply when
not in use, before fitting or removing parts and before
cleaning.
X Misuse could cause an injury.
X Always leave sufficient space around the appliance for
ventilation.
X Keep loose clothing, hair, jewellery etc. away from
moving parts.
X Care is needed when handling cutting blades,
especially when removing the blades from the bowl,
emptying the bowl and during cleaning.
X Do not use the appliance without either the jug or the
cap in place.
Safety of others
X Do not allow children or any person unfamiliar with
these instructions to use the appliance.
X Do not allow children or animals to come near the work
area or to touch the appliance or power supply cord.
Close supervision is necessary when the appliance is
used near children.
X This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been give supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
X Children must be supervised to make sure that they do
not play with the appliance.
After use
X Switch off the appliance before cleaning, changing
accessories or approaching parts which move in use.
X Switch off and remove the plug from the socket before
leaving the appliance unattended and before changing,
cleaning or inspecting any parts of the appliance.
X When not in use, the appliance should be stored in a dry
place. Children should not have access to stored
appliances.
Inspection and repairs
X Before use, check the appliance for damaged or
defective parts. Check for breakage of parts, damage to
switches and any other conditions that may affect its
operation.
X Do not use the appliance if any part is damaged or
defective.
X Have any damaged or defective parts repaired or
replaced by an authorised repair agent.
X Before use, check the power supply cord for signs of
damage, ageing and wear.
X Do not use the appliance if the power supply cord or
mains plug is damaged or defective.
X If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
X Never attempt to remove or replace any parts other than
those specified in this manual.
4
ENGLISH
Electrical safety
This tool is double insulated in accordance with
EN 60335; therefore no earth wire is required.
Always check that the power supply corresponds to
the voltage on the rating plate.
To avoid the risk of electric shock, do not immerse
the cord, plug or motor unit in water or other liquid.
Features
1. Cap
2. Cap/blender location
3. Rotary switch
4. Motor spindle
5. Blender jar
6. Measuring cup
7. Blender cap
8. Processor bowl
9. Food pusher
10. Processor bowl lid
11. Tool storage disc
12. Spatula
13. Blade carrier
14. Chopping blade
15. Coarse shredding blade
16. Fine shredding blade
17. Slicing blade
18. Blender blade
19. Plastic whisking disc
Unpacking
X Remove all packaging from the appliance,
X Clean the appliance before first use.
Use
Warning! Always place the appliance on a flat, clean and
non-slip surface before operating it.
Operating controls
The processor and blender control dials have the following
settings:
P - Pulse
0 - Off
1 - Speed 1 (Low)
2 - Speed 2 (Middle)
3 - Speed 3 (High)
The speed can be adjusted while the processor or blender is
in use.
Warning! Do not operate the food processor continuously
for more than 2 minutes. After operating the appliance
continuously for 2 minutes, let it cool down for at least 2
minutes before operating it again.
Using the processor bowl
The processor bowl (8) can be used to whisk, or chop large
quantities of food. See the section “Quantities and
processing times” in this manual.
X Place the appliance on a flat surface and make sure that
the speed selector is set at 0 (off).
X Make sure that the blender cap (1) or the blender jar (5)
is locked in position in the blender recess (2).
X Rotate the processor bowl lid (10) in an anti-clockwise
direction and lift it away from the bowl (8).
X Remove any accessories from the processor bowl (8).
X Select the required accessory.
X Make sure that the processor bowl (8) is locked in
position by rotating it in a clockwise direction.
The chopping blade (14), the knife frame (13) or the
whisk (19) can be placed directly over the central column of
the processor bowl (8). Rotating these items slowly will align
the hexagonal hole and drive on the motor spindle (4).
X Add the ingredients and place the lid (10) on the
bowl (8), rotating it clockwise until it locks in place. The
long tab on the lid (10) will engage in the slot in the
upper housing.
X Connect the appliance to the electrical supply and
select speed 1, 2, 3 or Pulse as required.
Additional ingredients can be added through the kidney-
shaped slot in the bowl lid (10) after removing the pusher (9).
The pusher must be used to guide the ingredients into the
path of the blade.
Warning! Always use the pusher to assist in processing
food, never use your fingers.
Using the blades
Warning! Make sure the food processor is unplugged from
the power source and switched off before fitting or removing
accessories.
The blades (14-17) must be fitted to the blade carrier (13)
before use.
X Place the required blade on the blade carrier (13), and
slide it forward until the tab fits into the slot. The blade
must then be gently pushed until it locks in position. To
remove the blade, grip the rim underneath it and pull it
away from the blade carrier (13).
X Once assembled, remove the processor bowl lid (10)
and, using the finger holes in the blade carrier (13) place
the blade carrier over the motor spindle (4).
X Replace the processor bowl lid (10).
5
ENGLISH
Ingredients can be added through the kidney-shaped slot in
the bowl lid (10) after removing the pusher (9). The pusher
must be used to guide the ingredients into the path of the
blade.
Using the blender jar
Use the blender jar (5) for the fine blending of raw
ingredients and blending of cooked ingredients to a very
smooth consistency.
Note: There is a convenient measuring cup fitted in the
blender lid (7).
See the section “Quantities and processing times” in this
manual.
Warning! Make sure the food processor is unplugged from
the power source and switched off before placing or
removing accessories.
X Remove any accessories from the processor bowl (8)
and refit the lid (10) and the pusher (9).
X Remove the cap (1) by rotating it in an anti-clockwise
direction.
X Add the ingredients to the blender jar (5) and fit the lid
(7), rotating it in an anti-clockwise direction until it locks
in place. Do not exceed the maximum mark.
X Place the blender jar (5) in the recess (2) and rotate it in
a clockwise direction until it locks in place.
Note: The blender jar cannot be fitted to the appliance
unless the lid (7) is correctly fitted to the jar.
Note: The blender lid (7) cannot be removed when the
blender jar (5) is fitted to the appliance.
Quantities and processing times
Cleaning and maintenance
Warning! Switch the appliance off and unplug it before
cleaning or maintenance.
Warning! Do not immerse the appliance, the cord set or the
plug in water or any other liquid.
Always clean the appliance immediately after use. Do not let
food dry on to the jug, cover or blades as this will make
cleaning difficult.
Do not wash any parts of the appliance, other than the
stainless steel blades, in a dishwasher.
Motor housing
X Wipe the motor housing with a damp cloth and dry
thoroughly. Do not use any abrasive or solvent-based
cleaner.
Blender jar
X To clean the blender jar (5), fill it with warm water and
washing up liquid, run for 30 seconds on maximum
speed and repeat as necessary.
Accessories and processor attachments
X Wash all the accessories and processor attachments by
hand, rinse with clean water and dry thoroughly.
Attachment Ingredient Quantity Speed Time
Chopping
Blade
Meat,
vegetables
800 g 3-Max 20-30 s
Soups, drinks 800 g 1 or 2 20 s
Potatoes and
fruit
700 g 2 or 3 15-20 s
Pastry,
scones
450 g 2 1 min
Cakes 1500 g 2 1 min
Coarse and
Fine
Vegetables,
cheese
800 g 1 2 min max
Shredding
Blade
Potatoes, fruit 950 g 1 2 min max
Slicing
Blade
Vegetables,
cheese
1000 g 1 2 min max
Fruit,
chocolate
1000 g 1 2 min max
Batons 1000 g 1 2 min max
Plastic
Whisking
Disc
Eggs 8 1 or 2 1-2 min
Blender Soup, purees,
drinks,
milkshakes
and batters
1.7 lt 1, 2, 3,
pulse
2 min max
6
ENGLISH
Stainless steel blades
Warning! Be careful when cleaning the blades; they are
sharp.
The stainless steel blades are dishwasher-safe items.
Protecting the environment
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black & Decker product
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again. Re-
use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
Black & Decker provides a facility for the collection and
recycling of Black & Decker products once they have
reached the end of their working life. To take advantage of
this service please return your product to any authorised
repair agent who will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local Black & Decker office at the
address indicated in this manual. Alternatively, a list of
authorised Black & Decker repair agents and full details of
our after-sales service and contacts are available on the
Internet at: www.2helpU.com.
Technical data
EC declaration of conformity
FP800
Black & Decker declares that these products conform to:
EN60335-1, EN60335-2-14, 2006/95/EC, EN50366
The undersigned is responsible for compilation of the
technical file and makes this declaration on behalf of
Black & Decker
Kevin Hewitt
Director of Consumer Engineering
Spennymoor, County Durham DL16 6JG,
United Kingdom
22-10-2007
Guarantee
Black & Decker is confident of the quality of its products and
offers an outstanding guarantee. This guarantee statement
is in addition to and in no way prejudices your statutory
rights. The guarantee is valid within the territories of the
Member States of the European Union and the European
Free Trade Area.
If a Black & Decker product becomes defective due to faulty
materials, workmanship or lack of conformity, within 24
months from the date of purchase, Black & Decker
guarantees to replace defective parts, repair products
subjected to fair wear and tear or replace such products to
make sure of the minimum inconvenience to the customer
unless:
X The product has been used for trade, professional or
hire purposes.
X The product has been subjected to misuse or neglect.
X The product has sustained damage through foreign
objects, substances or accidents.
X Repairs have been attempted by persons other than
authorised repair agents or Black & Decker service
staff.
To claim on the guarantee, you will need to submit proof of
purchase to the seller or an authorised repair agent. You can
check the location of your nearest authorised repair agent by
contacting your local Black & Decker office at the address
indicated in this manual. Alternatively, a list of authorised
Black & Decker repair agents and full details of our after-
sales service and contacts are available on the Internet at:
www.2helpU.com
Please visit our website www.blackanddecker.eu to
register your new Black & Decker product and to be kept up
to date on new products and special offers. Further
information on the Black & Decker brand and our range of
products is available at www.blackanddecker.eu.
FP800
Voltage Vdc 230
Power input W 800
Weight kg 5
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/
