Wells Manufacturing BMW-206STD Installation guide

Brand: Wells Manufacturing

Model: BMW-206STD

Type: Installation guide

WELLS BLOOMFIELD, LLC

2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439

telephone: 775-689-5707

fax: 775-689-5976

www.wellsbloomfield.com

p/n 306864 Rev. A ECN-13360 I 010 071024 cps

INSTALLATION INSTRUCTIONS

KIT# 506863

ELEMENT BRACKET CONVERSION

010

Page 1 of 1

• Element bracket kit# 506863 positions heating elements in

12x20 pan-style warmers.

• This kit replaces obsolete clips p/n 50397 and 50467.

PREPARATION

• Disconnect unit from electric power.

• Disassemble element pan from warmer.

• Remove and discard all existing element clips.

• On end panel away from element terminals, mark a line

1/2” (12.7mm) from top edge of panel. Locate and mark the

center of the panel.

• On end panel nearest element terminals, mark a line

5/32” (4mm) above centerline of element “keyhole” cutouts.

Locate and mark the center of the panel.

• Bend retaining tabs on brackets no more than 45º.

Each bracket has 2 tabs.

ASSEMBLY

• Attach the “U” shaped bracket to end panel away from element

terminals:

a. Center bracket on panel with the two bracket mounting

holes aligned with the 1/2” line.

b. Mark the location of the bracket mounting holes Drill a

1/16” diameter hole at each location.

c. Attach bracket to INSIDE of pan with provided drill-point

screws.

• Attach “I” shaped bracket to end panel nearest element

terminals:

a. Drill a 1/16” diameter hole at the at the intersection of the

centerline and the 5/32” line.

b. Attach bracket to INSIDE of pan with provided drill-point

screws.

• Install element on bracket.

• Bend retaining tabs to capture element.

NOTE:

Brackets locate element the proper distance from bottom of

pan, but allow element to expand and contract during heating

cycle. Be sure element is free to move laterally in bracket.

• Reassemble warmer and return to service.

CAUTION:

FIRE HAZARD

Disconnect from electric power

before servicing appliance.

CAUTION:

BURN HAZARD

Allow appliance to cool completely

before servicing.

Bend retaining tabs

no more than 45º.

45º

CENTERED

“I” SHAPED BRACKET

(FRONT)

“U” SHAPED BRACKET

(REAR)

Wells Manufacturing BMW-206STD Installation guide

Wells Manufacturing BMW-206STD Installation guide

Wells Manufacturing BMW-206STD Installation guide

Related papers

Other documents