Rabbit Air BioGS 2.0 Quick start guide

Brand
Rabbit Air
Model
BioGS 2.0
Type
Quick start guide
Complete these steps first before operating the unit.
Let’s Begin!
Quick Start Guide
Start Here
Next Page
Visit us at www.rabbitair.com
For questions, call 888.866.8862
24/7 customer care
BioGS 2.0 initial filter installation
Pre-Filter BioGS HEPA
Filter
Charcoal-Based
Activated Carbon
Filter
Front panel
1. Remove the front
panel by lifting from the
bottom and pulling up.
2. Pinch the two tabs on
top of the Pre-Filter to
remove it.
4. Remove the HEPA Filter and
discard its plastic wrapping.
3. Pull out the Activated Carbon Filter
and discard its plastic wrapping.
Complete these steps first before operating the unit.
Finishing up!
6. Reattach the front panel.
5. Return the filters to the filter case in the following
order from back to front:
BioGS HEPA Filter
Activated Carbon Filter
Pre-Filter
Meet the User Interface
The Air Quality readings are
based on both odor and
particle levels in the air.
• Air Quality Indicator
Indicates the current fan
speed of the unit.
• Fan Speed
Indicates the sensitivity of the
air quality sensors. The fan will
automatically adjust its speed.
• Auto Mode
Set the air purifier to turn off
after 4, 8, or 12 hours.
• Timer
Turn the Negative Ion
Generator on or off.
• Negative Ions
Tap to power on and change mode
Press & hold to power off
Air Quality
Pollutant level
Fan Speed
Auto Mode
Sensitivity level
Sleep Timer
Negative Ions
On/Off
4hr 8hr 12hr
Low • • • High
Low • • • High
Low Med High
On: Clean Filters
Flashing: Replace Filters
Filter Life Indicator
New Filters
15 Months
12 Months
9 Months
6 Months
3 Months
Press to turn off
Filter Maintenance Indicator
Press & hold to reset
Filter Life Indicator
Filter Maintenance Indicator
This feature can be accessed
through the main control
button.
This feature can be accessed
through the remote.
Device Control
(See page 8 in the manual)
Filter Status
(See page 11 & 12 in the manual)
Device Settings
(See page 9 & 10 in the manual)
©2019 Rabbit Air. All rights reserved. BioGSQS1909
The filter maintenance and replacement light
will illuminate based on how often and which
speed you operate your air purifier on. Based
on an algorithm that calculates the amount of
airflow and run time, your filter replacement
indicator will illuminate between 6 to 24
months. Your filter cleaning indicator will
illuminate between every 4 to 18 weeks.
  • Page 1 1
  • Page 2 2

Rabbit Air BioGS 2.0 Quick start guide

Brand
Rabbit Air
Model
BioGS 2.0
Type
Quick start guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents