12 GB
Q
Installing the product
1. Rotate the solar housing
2
anticlockwise out of the housing
9
.
2. Move the ON / OFF switch
8
into the ON position to switch
the product on.
3. Insert the solar housing
2
into the housing
9
and tighten by
turning it clockwise.
For model A/C, please make sure the solar housing
2
is in
correct position, the groove
6
must engage in the recess
3
in lamp shade (see fig.).
4. Take out the ground spike
10
from bottom of the housing
9
and insert it into the housing
9
with the tip facing downwards.
5. Your product is ready for use.
Q
Setting up the product
Insert the assembled product far enough into the ground
(lawn, flower bed) for it to be stable.
Make sure you keep proper footing and balance at all times.
Do not use any force when assembling or setting-up the prod-
uct, e.g. hammer blows. This will damage the product. In order
to achieve the best result, set the product up in a place where
the solar cell
1
will get direct sunlight for as long as possible.
Do not set the product up under bushes, trees, porches, etc.,
as this will reduce the amount of sunlight it receives.
Position the product in such a way that the solar cell
1
is not
covered or in shadow.
Make sure that the solar cell
1
is not influenced by any other
source of light such as yard or street lighting as otherwise the
light will not come on in twilight.